Loading ...
Loading ...
Loading ...
TROUBLESHOOTINGCHART
PROBLEM CAUSE CORRECTION
Lossofpower
Poorcut-uneven
Excessive
vibration
Starter rope hard
topoll
Grass catcher
notfilling (ifso
equipped)
Hard to push
1. Rear of lawn mower housing
or cuttingblade dragging
in heavy grass.
2. Cutting toomuch grass.
3. Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildupof grass, leaves
and trash under mower.
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
1. Engine flywheel brake is on
when controlbar is released.
2. Bent engine crankshaft.
3. Blade adapter broken.
4. Blade dragging in grass.
1. Cutting height too low.
2. Lift on blade wom off.
3. Catcher not venting air.
1. Grass is too high or wheel
height istoo low.
2. Rear of lawn mower
housing or blade dragging
in grass.
3. Grass catcher too full.
4. Handle height position not
right for you.
1. Set to "Higher Cut"
position.
2. Set to "Higher Cut"
position.
3. Clean/replace air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
1. Replace blade. 33ghten
blade bolt.
i
!2. Set all wheels at same
height
3. Clean underside of
mower housing.
1. Replace blade. 33ghten
blade belt.
2. Contact an authorized
service center.
1. Depress control bar to
upper handle before
pulling starter rope.
2. Contact an authorized
service center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting height.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to
suit.
16
Loading ...
Loading ...
Loading ...