Loading ...
Loading ...
Loading ...
SERVmCE AN ADJUSTMENTS
MID-WIDTH TILLING - 22" PATH (See Fig. 17)
° Assembte holes "A" in tine hubs to holes "C" in tine
shaft.
A C ! C A_-_._
FIG. 17
FINAL CHECK "ON" POSITION
• Withtine control"ON" (held down to handle) push down
on handle to raise tines off the ground_
, Slowly pull recoil starter handle while observing tines.
Tines should rotate forward_
, If tines do not rotate, inner wire of control cable is too
loose Loosen cable clip and pull cable up to remove
slack and retighten clip,
, Recheck in "ON" position and adjust if necessary.
NOTE: If "ON" position check required adjustment, re-
check "OFF" position adjustment to insure tines do not
rotate when control is "OFF" (up).
NARROW TILLING/CULTIVATING - 12-3/4" PATH (See
Fig. t8)
• Remove outer tines..
o o
oil i lO
INNER TINES ONLY
ool
FIG. 18
NOTE: When reassembling outer tines, be sure right tine
assembly (marked "R") and left tine assembly (marked "L")
are mounted to correct side of tine shall
TINE OPERATION CHECK (See Fig. 19)
i .... i i iii ...11.... ll...,i...r.lf_.l_
I _ WARNING_ Disconnect spark PIL_g wire I
from spark phlg to prevent starting I
while checking fine operation, I
For proper tine operation, tine control lever must be against
control body and a!l slack removed from inner wire of
control cable when control is in the "OFF" (up) position..
If lever and cable are loose, loosen cable clip at lower end
of cable. Pull up on cable to remove slack, without
extending spring on end of cable, and retighten cable clip.
FINAL CHECK "OFF" POSITION
, With tine control "OFF" (up), push down on handle to
raise tines off the ground.
• Slowly pull recoil starter handle while observing tines.
Tines should not rotate
o If tines rotate, inner wire of control cable is too tight
which is extending lower spring and engaging tines.
Loosen cable clip and push down on cable only enough
to relieve spring tensionr. Tighten cable clipo
o Recheck in "OFF" position and adjust if necessary.
TINE CONTROL
"OFF" POSITION "_
"ON" POSITION r_uuT 'k_ \
CABLE CONTROL
CLIP CABLE
/
FIG. 18
15
Loading ...
Loading ...
Loading ...