Loading ...
Loading ...
Loading ...
Problem solving guide
68
Message Cause and remedy
Clean the fluff filter.
Check the airways.
The plinth filter looks clean after thorough cleaning.
However, the programme terminates and the fault
message appears again. It is likely that there is still
underlying residue that could not be removed.
To deactivate the message, confirm with OK.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in “Problem solving guide – Checking the heat ex-
changer”.
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions de-
scribed in “Problem solving guide – Replacing the
plinth filter”.
If the plinth filter is not out of shape or damaged,
you can reactivate it in a washing machine. Follow
the instructions described in “Problem solving
guide – Reactivating the plinth filter”.
Empty the container
or check the drain
outlet
The condensed water container is full or there is a
kink in the drain hose.
Open and close the door with the tumble dryer
switched on to clear the message. Or switch the
tumble dryer off and then on again.
Empty the condensed water container.
Check the drain hose.
Obstruction detec-
ted. Untangle laun-
dry and restart.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. If neces-
sary, take out some of the laundry.
Switch the tumble dryer off and then on again.
Start a programme.
Fault F. If restart
fails, call Service.
There is no obvious cause.
Switch the tumble dryer off and then on again.
Start a programme.
If the programme is cancelled again with the same
fault message, then there is a fault. Contact the Miele
Customer Service Department.
Loading ...
Loading ...
Loading ...