Kenmore 66561622100 Microwave Hood Combination

Use & Care Guide - Page 7

For 66561622100. Also, The document are for others Kenmore models: 665.61622, 665.61624, 665.61627, 665.61629

PDF File Manual, 84 pages, Read Online | Download pdf file

66561622100 photo
Loading ...
Loading ...
Loading ...
Installation Instructions
REMOVING AND REPLACING THE MICROWAVE OVEN
Excessive Weight Hazard
Use two or more people to move and install
microwave oven,
Failure to do so can result in back or other
injury.
If you need to remove your Microwave Hood
Combination for any reason, follow these simple
steps:
To remove:
1. Unplug microwave oven or disconnect power.
2. Remove filters and vent grille.
.__ If filters Q are in-
stalled, push in at the
tab and slide filter to
the outside edge to re-
- _-- move.
[_r----------_ ' Remove the two
screws Q from the top
of the microwave oven
""" cabinet (the screws
located closest to the
front corners). Do not
remove the screws located towards the center of
the cabinet.
Remove the vent grille (_. Set the screws and
grille aside.
3. After removing all oven contents, including the
turntable and support,
tape the door in the
closed position. Then
remove the two
screws _) securing the
microwave oven to the
upper cabinet.
4, While wearing gloves, grasp the microwave oven
supports @ and firmly
pull the microwave oven
forward and downward to
release the microwave
oven cabinet from the
mounting plate locking
pins _.
5, Grasp the microwave oven cabinet. Rotate the
microwave oven down-
ward. (Be careful that
door does not swing
open.) Lift off the sup-
port tabs O at the bot-
tom of the mounting
plate. Set the micro-
wave oven aside on a
protected surface.
To replace:
1, Carefully lift microwave oven and hang it on the
support tabs at the bottom of the mounting plate.
2. Rotate the front of the microwave oven cabinet
downward. Thread the power supply cord
through the power supply cord hole in the
bottom of the upper cabinet.
3. Rotate the microwave oven towards the cabinet.
Push the microwave oven against the mounting
plate until locking pins snap into the cabinet.
4. Replace the two screws securing the microwave
oven to the upper cabinet.
5. Untape the door and replace the turntable and
support.
6. Replace the vent grille.
7. Replace the two screws in the top of microwave
oven cabinet (the screws located closest to
front corners).
8. If filters were installed, replace them (see "Install-
ing and caring for the filters" in the "Caring for
Your Microwave Oven" section, if needed).
g. Plug in microwave oven or reconnect power.
Loading ...
Loading ...
Loading ...