Loading ...
Loading ...
Loading ...
26
INSIDE OF OVEN
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm water.
Suitable proprietary chemical cleaners may be used after rst consulting with the
manufacturers recommendations and testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity surface.
NOTE: The manufacturers of this appliance will accept no responsibility for damage caused
by chemical or abrasive cleaning.
Donotstoreammablematerialintheoven.
Let the oven cool down and pay special attention no to touch the hot heating
elements inside the oven cavity.
REPLACING THE HALOGEN OVEN LIGHT
WARNING: Ensure the appliance is switched off before replacing the lamp to avoid
the possibility of electric shock.
■ Let the oven cavity and the heating elements to cool down.
■ Switch off the electrical supply.
■ Remove the protective cover “C” (g. 21).
■ Replace the halogen lamp “B” with a new one suitable for high temperatures having
the following specications: 220-240V or 230-240V, 50 Hz and same power (check
watt power as stamped in the bulb itself) of the replaced lamp.
IMPORTANT WARNING: Never replace the lamp with bare hands; contamination
from your ngers can cause premature failure. Always use a clean cloth or
gloves.
■ Ret the protective cover “C”.
NOTE: Oven bulb replacement is not covered by your guarantee.
B
C
WRONG
CORRECT
Figure 21
Loading ...
Loading ...
Loading ...