Loading ...
Loading ...
Loading ...
Transporting and Mounting
!<B;A6;4==960.A6<;@
*<?8/2;05$2?:.;2;AAA.05:2;A
1. Each of the four mounting holes should be bolted
securely using 5/16" bolts, lock washers and hex
nuts (not included).
2. Locate and mark where the saw is to be mounted.
3. Drill four 5/16" diameter holes through work-
bench.
4. Place the miter saw on the workbench, aligning
holes in base with holes drilled in workbench.
Install bolts, lock washers and hex nuts.
9A2?;.A2AA.05:2;A
The smaller mounting holes at each corner can be
used for nails or longer drywall screws.
The supporting surface where the saw is to be
mounted should be examined carefully after
mounting to ensure that no movement can occur
during use. If any tipping or walking is noted, secure
the workbench or stand before operating the miter
saw.
20.?23B9 ;<AA< <C2?1?6C2;.69
<? <C2?A<?>B2 A52 /<9A '56@
0<B910?.083<<A<?1.:.42/.@2
64B?2*<?8/2;05!<B;A6;4
'2:=<?.?F!<B;A6;4(@6;49.:=@
l If necessary, clamp the miter saw to a workbench
or table top.
l Place two or more “C” clamps on the clamping
areas and secure (see Figure 29). There are
clamping areas at all four corners of the saw.
l Be careful not to place clamps over the base
extension clamping levers (see Figure 29).
l Mounting with clamps may prevent access to
some wide miter angles.
64B?2'2:=<?.?F!<B;A6;4(@6;49.:=@
('#"
!
Bolt Hole
Nail Hole
Rear
Mounting
Holes
Clamping Area
Clamping Area
BM 2610007877 04-10:BM 2610007877 04-10.qxp 4/26/10 8:13 AM Page 27
Loading ...
Loading ...
Loading ...