Loading ...
Loading ...
Loading ...
Reversing the Doors
The doors can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the
appliance on its
back with the
doors
uppermost.
2. Remove the
upper hinge.
3. Move the plastic plugs to where the
upper hinge was fitted.
4. Lift off the upper door and lay it aside.
5. Remove the middle hinge by
unscrewing the screws.
6. Lift off
the lower
door and
lay it aside.
9.
R
emove the
lower
hinge.
Rotate the
hinge
through
180° and
refit it on
the
opposite side of the appliance.
10. Refit the kick plate
7. Remove the kick plate by pulling it
outwards and upwards.
8. Loosen lock nut with the fork
wrench enclosed and move the
pin.
11. Remove the door-closer and refit
it on
the opposite side.
12. Remember to pull the pin in the
door closer
towards
the side
before
fitting the
door.
13. Fit the
upper door.
14. Fit the
upper hinge.
15. Remove the
door handles
and refit
them on the
opposite
side.
Refit the
caps.
16. The
appliance
must be
allowed to
stabilise in an
upright
position for at
least 1 hour
before being
switched on.
17. After
reversing the
door(s), it is
important to
check that the
sealing strip
provides a
tight seal all
the way
round.
If it
does not,
carefully
heat the
strip all the
way round
using a hair
dryer. Then
ease the
strip
outwards
slightly so
that it forms
a tight seal
against the
cabinet. Be
careful not
to heat the
strip so
much that it
melts!
9
Loading ...
Loading ...
Loading ...