Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART
PROBLEM CAUSE
1. Rear of lawn mower housing
or cutting blade dragging
in heavy grass.
2. Cutting too much grass.
Loea of power
Poor cut - uneven
iExcessive
vibration
Starter rope hard
topull
Grass catcher
not filling (ifso
equipped)
Hard to push
3. Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass,leaves
and trashundermower.
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
1. Engineflywheelbrake ison
when controlbar isreleased.
2. Bent engine crankshatt.
3. Blade adapter broken.
4. Blade dragging in grass.
1. Cutting height too low.
2. I_itton blade wom off.
3. Catcher not venting air.
1. Grass is too high or wheal
height is too low.
2. Rear of lawn mower
housing or blade dragging
in grass.
3. Grass catcher too full.
4. Handle height position not
rightfor you.
CORRECTION
1. Set to "Higher Cut"
position.
2. Set to"Higher Cut"
position.
3. Clean/replaceair filter.
4. Clean undersideof mower
housing.
5. Check oillevel.
5. Cut at slowerwalking
speed.
.
3.
Replaceblade. "lighten
blade bolt.
Set allwheels at same
height
Clean underside of
mower housing.
1. Replace blade. T_jhten
blade belt.
2. Contactan authorized
service center.
1. Depresscontrolbarto
upper handlebefore
pulling starterrope.
2. Contactan authorized
servicecanter.
3. Replace Uade adapter.
4. Move lawn mower to cut
grass or to hard surface
to startengine.
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting heighL
2. Raise rear of lawnmower
housingone (1) setting
higher.
3. Emptygrasscatcher.
4. Adjusthandleheightto
suit.
16
Loading ...
Loading ...
Loading ...