Loading ...
Loading ...
Loading ...
8
WALL MOUNT INSTALLATION
***This installation requires to have Duct Cover Model No. CH1120DC-1
Preparation before Installation
-
Temporarily wire the hood to test for proper
operation before installing. If the hood does
not operate, check the circuit breaker or
house fuse. If the hood is still not working,
disconnect power supply and check the
continuity of all wire connections.
-
Peel protective film off the hood (if any).
-
If necessary, prepare back wall frame with cross
framing lumber for secure installation. Using
references on Table 2 and measurements on
page 13-14, decide the level of the lumber.
Refer to Figure 3.
Hood Installation
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. And use a protective covering to
protect cooktop and/or countertop from
damage.
1. Secure Hood-Mounting Bracket {K} and two
Duct Cover Support {J} on top of the hood with
eight pre-attached screws. Use four 3/16” x 3/8”
screws {J} for Hood-Mounting Bracket {K}.
(Figure 4)
2. Using references on Table 2 and
measurements on page 13-14, mark the
leveling point of the hood. Position two
mounting screws (provided) on the wall, leaving
1/8” away from the wall as shown in Figure 5.
3. Align Hood-Mounting Bracket {K} to the two
screws on the wall and hook hood into place.
Tighten screws to secure hood to the wall.
CAUTION
: MAKE SURE HOOD IS
SECURE BEFORE RELEASING
Figure 3
Figure 4
Figure 5
Mounting Screws
Loading ...
Loading ...
Loading ...