Loading ...
Loading ...
Loading ...
PERFORMANCE DATA SHEET
Base Grille Water Filtration System
Model T1 KB2/T1 RFKB2 Capacity 200 Gallons (757 Liters) without Filter Indicator Light
System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction
of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the
reduction of Lead, Mercury, Atrazine, Benzene, Toxaphene, O-Dichlorobenzene, Cysts, Turbidity,
Asbestos, Lindane, Tetrachloroethylene, Endrin, Alachlor, Chlorobenzene and Ethylbenzene.
This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system, as specified in NSF/ANSl Standards 42 and 53.
Substance Reduction
Aesthetic Effects
Chlorine Taste/Odor
Particulate Class I*
Contaminant
Reduction
Lead: @ pH 6.5
Lead: @ pH 8.5
Mercury: @ pH 6.5
Mercury: @ pH 8.5
Benzene
O-Dichlorobenzene
Toxaphene
Atrazine
Asbestos
Live Cysts _
Turbidity
Alachlor
Endrin
Ethylbenzene
Lindane
Chlorobenzene
Tetrachloroethylene
NSF Reduction Average Influent Challenge
Requirements Influent Concentration
50% reduction 2.0 mg/L 2.0 mg/L + 10%
85% reduction 3533333#/mL At east 10,000 partces/mL
NSF Reduction Average Influent Challenge
Requirements Influent Concentration
0.010 mg/L 150 ug/L 0.15 mg/L + 10%
0.010 mg/L 157 ug/L 0.15 mg/L _+10%
0.002 mg/L 0.0058 mg/L 0.006 mg/L + 10%
0.002 mg/L 0.0057 mg/L 0.006 mg/L _+10%
0.005 mg/L 15 ug/L 0.015 mg/L _+10%
0.6 mg/L 1750 ug/L 1.8 _+10%
0.003 mg/L 15 ug/L 0.015 _+10%
0.003 mg/L 10 ug/L 0.009 mg/L _+10%
99% 101 MFL 1OTto 108fibers/L tt
>99.95% 120,000/L 50,000/L min.
0.5 NTU 11.4 NTU 11 _+1 NTU
0.002 mg/L 41.3 ug/L 0.04 _+10%
0.002 mg/L 5.9 ug/L 0.006 _+10%
0.7 mg/L 1867 ug/L 2.1 _+10%
0.002 mg/L 1.9 ug/L 0.002 _+10%
0.6 mg/L 2.0 ug/L 2.0 _+10%
0.005 mg/L 14.2 ug/L 0.015 _+10%
Maximum
Effluent
0.08 mg/L **
22000 #/mL
Maximum
Effluent
1 .Oug/L
2.0 ug/L
0.0002 mg/L
0.0002 mg/L
0.5 ug/L
1 .Oug/L
1 .Oug/L
2 ug/L
0.17 MFL
8/U
0.41 NTU
0.2 ug/L
0.5 ug/L
0.70 ug/L
0.02 ug/L
0.0005 ug/L
0.5 ug/L
Average
Effluent
2.0 mg/L
11567 #/m L
Average
Effluent
1 ug/L
1.08 ug/L
0.0002 mg/L
0.0002 mg/L
0.5 ug/L
1.O ug/L
1 .O ug/L
2 ug/L
0.17 MFL
1/ U
0.24 NTU
0.2 ug/L
0.3 ug/L
0.0588 ug/L
0.02 ug/L
0.0005 ug/L
0.5 ug/L
Minimum %
Reduction
95.93
99.38
Minimum %
Reduction
99.33
98.72
96.53
96.5
96.67
99.94
93.33
80.8
99.83
99.99
96.4
99.52
91.5
99.96
98.93
99.98
96.47
Test Parameters: pH = 7.5 _+0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters).
• It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
• Model T1KB2: Change the water filter cartridge every 6 months.
If the water flow to the water dispenser or ice maker decreases
noticeably before 6 months have passed, replace the water filter
cartridge more often.
Use replacement cartridge T1 RFKB2, part #9030.
2008 suggested retail price of $59.99 U.S.A./S71.99 Canada.
Prices are subject to change without notice.
• These contaminants are not necessarily in your water supply.
While testing was performed under standard laboratory
conditions, actual performance may vary.
• The product is for cold water use only.
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the
system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Average %
Reduction
97.36
99.67
Average %
Reduction
99.33
99.31
96.53
96.5
96.67
99.94
93.33
80.8
99.83
>99.99
97.89
99.52
95.47
100
98.93
99.98
96.47
• Refer to the "Warranty" section for the Manufacturer's name,
address and telephone number.
• Refer to the "Warranty" section for the Manufacturer's limited
warranty.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure 30 - 120 psi (207 - 827 kPa)
Water Temperature 33 ° - 100°F (0.6 ° - 37.8°C)
Service Flow Rate 0.5 gpm (1.9 L/min) @ 60 psi
*Class I particle size: >0.5 to <1 um
**Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.
ttFibers greater than 10 um in length
€Based on the use of Cryptosporidium parvum oocysts
® NSF is a registered trademark of NSF International.
27
Loading ...
Loading ...
Loading ...