Loading ...
Loading ...
Loading ...
- 10 -
Pull out the top duct as far as the bracket and fix it using screws F (Fig.11C).
• RECIRCULATING RANGEHOOD
To replace the active carbon filter first remove the aluminium filter by pulling lever B outwards. The filters
must then be fitted to the suction inlet of the motor. To fit the filter it must be centred then rotated clockwise
90 degrees to lock (Fig.10).
• OPTIONAL ACCESSORIES - CARBON FILTER
If you have recirculated the rangehood, we recommend that you install carbon filters.
Order from your retailer.
Refer to figure 10 for installation.
USE AND MAINTENANCE
• It is recommended to operate the appliance prior to cooking.
It is recommended to leave the appliance in operation for 15 minutes after cooking is terminated in order to
help eliminate rangehood vapours and odours.
The proper function of the rangehood is conditioned by the regularity of the maintenance operations, in
particular, the active carbon filter.
• The anti-grease filters capture the grease particles suspended in the air, and are therefore subject to
clogging according to the frequency of the use of the appliance.
In order to prevent fire hazard, it is recommended to clean the filter every 2 months by carrying out the
following instructions:
- Remove the filters from the rangehood and wash them in a solution of water and neutral liquid detergent,
leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminium panels may alter in colour after several washes. This is not cause for customer complaint nor
replacement of panels.
• The active carbon filters help to purify the air that is replaced in the environment. The filters are not
washable nor re-useable and must be replaced at maximum every four months. The saturation of the active
carbon filter depends on the frequency of use of the appliance, by the type of cooking and the regularity of
cleaning the anti-grease filters.
• Clean the fan and other surfaces of the rangehood regularly using a cloth moistened with denatured
alcohol or non abrasive liquid detergent.
• The illumination installation is designed for use during cooking and not for prolonged general illumination of
the environment. Prolonged use of the illumination installation notably reduces the duration of the bulb.
• LIGHT REPLACEMENT - HALOGEN
12 volt 20 W Halogen.
Remove the glass retaining ring and glass.
Replace the globe with another of the same type.
Replace the glass and retaining ring.
CONTROLS : (Fig.13)
Touch control A = on/off lights switch
Touch control B = on/off rangehood switch. The appliance switches on at speed level 1, If the rangehood
is on depress the touch control for 2 sec. to switch off the rangehood. If the rangehood is at speed level 1 it
will not be necessary to depress the touch control to switch the rangehood off. Decreases the motor speed.
Display C = indicates the motor speed level selected and activates the timer.
Touch control D = switches on the rangehood. Increases the motor speed. Touching the key at 3rd speed,
the intensive function runs for 10', then the appliance go back to work at the original speed. During this
function the display blinks.
Touch control E = The Timer times the functions on activation for 15 minutes, after which they are switched
off. The Timer is deactivated by re-pressing Touch control E. When the Timer is activated the decimal point
must flash on the display. The Timer cannot be activated if the intensive speed is functioning.
The “clean air” function is activated by pressing Touch control E for 2 seconds when the appliance is switched
off. This switches the motor on for 10 minutes every hour at the first speed. During functioning a rotary
Loading ...
Loading ...
Loading ...