Loading ...
Loading ...
Loading ...
16
The original packaging has been designed for dispatch by post. Keep it in case you need to return the kettle
to the supplier. Before installing the kettle, comply with all the points of the safety instructions on the
previous pages. After removing the kettle from its packaging, make sure that it is in perfect condition and
make sure that no kind of matter, packaging material, warranty sheets or the like have accidentally fallen
inside the kettle during transport or when opening the packaging.
The plastic bag in which the kettle is packaged should be kept out of reach of children as it poses a suf-
focation hazard. Be sure that the kettle is in perfect conditions. In order to remove dust that may have
accumulated on the exterior surfaces of the kettle, simply dust it off with a dry soft cloth.
After you have carried out the above steps and have strictly followed the safety standards, proceed to
connect to the power supply.
Connecting to power supply: electric current can kill! Follow safety instructions!
Plug the power cord (6) of the Vera kettle into a power socket of the same voltage of the one indicated on
the rating plate underneath the kettle.
Rinse out carefully all the internal surfaces and the spout of the kettle: ll the kettle with water until the
maximum level (1700 ml/ 57.48 US .oz / 59.80 UK .oz), boil it and empty the boiler. Repeat at least two
times.
Fill the kettle:
a) remove the kettle body from the power base unit (5). Hold it by the handle (3)
b) open the lid (1) : press on the rubber “point” (picture “a”) on the lid (1) and press down rmly (picture
“b”). Then release (picture “c”) and the lid (1) will open automatically. The lid (1) is not removable and
the max opening is shown in the picture “d”.
c) ll the kettle with water directly under the tap or ll it by pouring water from a bottle, jug or jar to the
needed level. Do not overll the kettle. Be careful not to go over 1700 ml (57.48 US .oz / 59.80 UK .oz).
d) close the lid (1) : press on the rubber “point” (picture “a”) on the lid (1). Never operate the kettle with
the lid (1) open.
e) Put the kettle on the base (5).
f) To boil water just push on the on/off button (9). The light in the on/off button (9) shows that the kettle
is working.
When the boiling session is nished, the kettle automatically switches off.
To disconnect, make sure that the kettle is not running. Do not unplug the kettle from the wall outlet by
pulling on the cord. Always unplug the appliance by holding the plug (6). To switch off completely the devi-
ce, the plug (6) has to be removed from the socket.
Installation and starting up
Loading ...
Loading ...
Loading ...