Loading ...
Loading ...
6
FOR CARE AND MAINTENANCE:
·The water in certain areas of the world can be very caustic -
standing water around the product can cause damage. Be
sure to remove standing water with a dry, soft cloth as soon
as possible.
·For polished brass finishes, as often as once a week, you
can apply a paste wax or special, non-abrasive, brass
coating (DO NOT APPLY POLISH).
·Before applying a protective coating, gently brush the entire
fixture using a soft tooth brush. This will remove any dirt or
deposit build-up.
·These simple steps will add temporary protective coating to
your faucet and extend the life of the finish.
Failure to follow care and cleaning will void your warranty.
For additional information, please visit elkayusa.com.
CARE AND CLEANING INSTRUCTIONS
FLOW REGULATOR REPLACEMENT
This faucet ships with a 1.5GPM aerator installed. An
optional 2.2GPM aerator is also included in the box.
To switch the flow rate of the faucet:
1. Disassemble aerator assembly by separating the
aerator shell (1), aerator (2) and washer (3). Remove
existing aerator (2) and install the new aerator.
(2.2GPM=Red, 1.5GPM=Green)
2. Reinstall the aerator assembly.
Congratulations on your purchase of an Elkay product.
Although your product is extremely durable, attention should
be given to the care, cleaning and maintenance of this
product. Cleaning agents and abrasives may cause damage,
which may result in oxidation and discoloration.
By following these simple guidelines for proper care and
cleaning, it will give you years of enjoyment:
TO CLEAN: Simply wipe gently with a damp cloth and blot dry
with a soft towel. A common rule of thumb is: when you dry off,
dry off your product.
· Avoid build-up of soap, toothpaste or mineral deposits, as
these tend to have an adverse effect on the appearance of
the product.
· NEVER use cleaning products of any kind on this product -
especially those containing ammonia, bleach or alcohol - or
those with any form of abrasive.
Shut off water supply. Remove set screw plug (1). With
valves in "closed" position, unscrew set screw (2) and
remove handle (3) from valve stem (4). Loosen the
screw (7) from valve stem (4). Loosen the cap (5) from
the sleeve (6).
3
1
2
Loosen sleeve (1) by turning it counter-clockwise and lift
out the cartridge (2). Remove the old cartridge and
replace with the new cartridge. Replace sleeve and
tighten. Reinstall the handle.
CARTRIDGE REPLACEMENT
3
5
7
4
1
2
2
1
Loading ...