Loading ...
Loading ...
Loading ...
STEP 2
Add Detergent
NOTE: If you do not plan to run a wash cycle soon, run a rinse
cycle. Do not use detergent.
• Use automatic dishwasher detergent only. Add powder, liquid
or tablet detergent just before starting a cycle.
• Fresh automatic A
dishwasher detergent
results in better
cleaning. Store tightly
closed detergent
container in a cool, dry
place.
A. Cover latch
B.Main Washsection
C. Pre-Washsection
• The amount of
detergent to use depends on:
How much soil remains on the items - Heavily soiled loads
require more detergent.
The hardness of the water - Ifyou use too little in hard water,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Soft to Medium Water (0-6 grains per U.S. gallon)
[typical water softener water and some city water]
Medium to Hard Water (7-12 grains per U.S. gallon)
[well water and some city water]
• Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.
NOTE: Fill amounts shown
are for standard powdered
detergent. Follow instructions
on the package when using
other dishwasher detergent.
Add Rinse Aid
HardWater
S0ftWater
HardWater
SoftWater
MainWash Pre-Wash
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
Rinse aid helps to reduce excess moisture on the
dish racks and interior of your dishwasher.
Full
Add
• Check the rinse aid indicator. Add rinse aid when indicator
drops to "Refill" level.
To add rinse aid, turn the dispenser
cap to "Open" and lift off. Pour rinse
aid into the opening until the indicator
level is at "Full." Replace the
dispenser cap and turn to "Lock."
Make sure cap is fully locked.
NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting
a flat-blade screwdriver into the center
of the arrow and turning.
Lock
Refill__
turn to lock
STEP3
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts inthe following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 31/2hours to complete.
CYCLES
m m []
I HeavyWash I NormalWash I[ China/
Crystal
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts inthe following
section.
You can customize your cycles by pressing the options desired.
OPTIONS
[] [] []
[s% i Son,t,zoI [
) STEP 4
Start or Resume a Cycle
• Run hot water at the sink nearest your
dishwasher until the water is hot. Turn off water.
[]
Push door firmly closed. The door latches I Start/
automatically. Select the wash cycle and . Resume
options desired OR press START/RESUME to
repeat the same cycle and options as in the previous wash
cycle.
You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
Loading ...
Loading ...
Loading ...