Loading ...
Loading ...
Loading ...
7
OPERATION
• The appliance should be placed where the ambient temperature is between 10~38°C
(50~100°F). If the ambient temperature is above or below this range, the performance of the unit
may be affected. Placing your unit in extreme cold or hot conditions may cause interior
temperatures to fluctuate.
• Connect power cord to a properly grounded outlet.
• This appliance is equipped with Memory IC – should there be a power interruption, unit will auto
recover at last setting.
Control Panel
ON/OFF Power
To turn the appliance on or off, press and hold the ON/OFF button for 3 seconds.
Setting the temperature Control
• Adjustable temperature: 1°C to 20°C (34°F to 68°F)
• Set the desired cooling temperature by pressing the corresponding button or . Each
depression of the buttons will raise or lower the temperature setting by 1 degree. The
temperature selected will flash in the LED display for approximately 5 seconds, then revert back
to displaying the temperature of the cabinet interior.
°C/°F
This unit has the option of displaying temperatures in either Celsius or Fahrenheit. To change the
setting, press the °C/°F button.
NOTES:
• If the unit is unplugged, turned off or experienced a power failure, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the appliance will not
start.
• When you use the appliance for the first time, or restart after having been shut off for a long time,
there could be a few degrees variance between the set temperature and the displayed
temperature on the LED readout. This is normal and is due to the length of inactivity. Once the
unit runs for a few hours, everything will be back to normal.
Defrosting
• The unit defrosts automatically in normal operating conditions. The evaporator behind the rear
wall of the unit defrosts automatically. The condensate collects in the drainage channel behind
the rear wall of the unit, and flows through the drainage hole into the drip tray by the compressor
where it evaporates.
• However, frost may accumulate on the evaporator if the unit is repeatedly opened in a high heat
or high humidity location. If this frost pattern does not clear within 24 hours, your unit will require
manual defrosting.
Loading ...
Loading ...
Loading ...