Loading ...
Loading ...
Loading ...
Before You Call ..................................................
Won't fill
Won't agitate
Won't spin or drain
Load is wet
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer. If
equipped with buttons, be sure they are fully depressed.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Check fuse or reset circuit breaker.
• Make sure lid is completely closed.
• Turn the control knob to proper cycle and pull knob out to start the washer. If
equipped with buttons, be sure they are fully depressed.
• Close lid and pull knob out to start the washer. For your safely, washer will
not agitate or spin unless the lid is closed.
• The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop operations for your safely. Call for
service.
• Unevenly distributed load. Redistribute the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable for load size.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
• Close lid and pull knob out to start the washer. For your safely, washer will
not agitate or spin unless the lid is closed.
• The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop operations for your safely. Call for
service.
• Suds lock - caused by too much suds. Rewash without detergent. Use correct
amount of a low-sudsing detergent.
• The washer may have sensed an unevenly distributed load. Redistribute the
load in the tub, close the lid and pull the control knob out.
• A normal spin speed is recommended for heavy loads like jeans or towels.
8
Loading ...
Loading ...
Loading ...