Husqvarna 7021RB lawn mower

User Manual - Page 7

For 7021RB.

PDF File Manual, 18 pages, Download pdf file

Loading ...
Loading ...
Loading ...
OPERATION
DRIVE CONTROL (See Fig. 6)
* Self-propelling is controlled by holding the operator
presence control bar down to the handle and pulling
either drive control lever rearward to the handle. The
further toward the handle a lever is pulled, the faster
the unit will travel.
Forward motion will stop when either the operator pres-
ence control bar or adrive control lever are released. To
stop forward motion without stopping blade, release a
drive control lever only. Hold operator presence control
bar down against handle to continue mowing without
self-propelling.
NOTE: If after releasing the drive control the mower will
not roll backwards, push the mower forward slightly to
disengage drive wheels.
OPERATOR PRESENCE CONTROL BAR
TO ENGAGE DRIVE
CONTROL
DRIVE
CONTROL
LEVERS
DRIVE CONTROL
DISENGAGED
FIG. 6
DRIVE CONTROL ADJUSTMENT (See Fig. 7)
Over time, the drive control system may become "loose",
resulting in decreased speed. There is a turnbuckle on
the drive control housing to increase tension on the drive
cable. Proceed as follows:
1. Turn unit offand disconnect spark plug wire from spark
plug.
2. Rotate turnbuckle on drive control to increase drive
speed.
3. Operate mower to test drive speed. Readjust as re-
quired.
4. If condition fails to improve after the above steps
(forward speed remains the same), your drive belt is
worn and should be replaced.
ADJUSTMENT
TURNBUCKLE
FIG. 7
TO ADJUST CUTTING HEIGHT (See Fig. 8)
All four wheels are adjusted by a single lever.
Pull adjuster lever toward wheel. To raise mower, move
lever forward to desired position, Tolower mower, move
the lever toward the rear.
WHEEL
ADJUSTER
LEVER
LEVER BACKWARD TO
LOWER MOWER
LEVER
FORWARD TO
RAISE MOWER
FIG. 8
TO ATTACH GRASS CATCHER (See Fig. 9)
1. Lift the rear door of the lawn mower and place the
grass catcher frame side hooks onto the door pivot
pins.
2. The grass catcher issecuredtothe lawn mower housing
when the rear door is lowered onto the grass catcher
frame.
A
CAUTION: Do not run your lawn mower
without mulcher plug or approved grass
catcher in place. Never attempt to op=
erate the lawn mower with the rear door
removed or propped open.
PIVOT PINS
REAR DOOR
GRASS
CATCHER
HANDLE
CATCHER FRAME HOOK
FIG. 9
7
Loading ...
Loading ...
Loading ...