Loading ...
Loading ...
Loading ...
SECTION 4: UNPACKING INSTRUCTIONS
• See Figure 3.
• Remove staples, break glue on the top flaps of the carton or cut tape at carton end and peel along top flap
to open carton. Remove any loose parts included with unit (i.e., Operator's manual, etc.).
• Cut along dotted lines and lay end of carton down flat. Remove packing material.
• Roll unit out of carton. Check carton thoroughly for loose parts.
REMOVE MANUAL & LOOSE PARTS
Figure 3
SECTION 5: SET- UP INSTRUCTIONS
This Operator's Manual covers several models of snow throwers. Much of the Manual pertains to all of the
models. However, there are some areas where only one model is covered. Use only the information that is
appropriate for your model.
ITEMS REQUIRED FOR SET-UP
• Pair of pliers (not necessary, but helpful)
• 2 cycle oil
• Fresh Gasoline
IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. See separate Engine Operator's Manual
for proper fuel and two cycle engine oil recommendations.
Note: Reference to right or left hand side of the snow thrower isfrom the operating position
CONTENTS OF HARDWARE PACK
• (2) IgnitionKeys (One may be in the switch on snow thrower)
Models with Optional Extended Chute Crank:
• (1) Eyebolt
• (1) Saddle Washer 5/16" I.D.
• (2) Hex Nuts 5/16-18 Thread
• (1) CotterPin
5
Loading ...
Loading ...
Loading ...