Loading ...
Loading ...
Loading ...
18
If you experience Possible Causes Solution
Washer not performing as expected (cont.)
Incorrect dispenser
operation
Clogged dispensers or laundry
products dispensing too soon�
Do not overll dispenser. Overlling causes immediate dispensing.
Always select Fabric Softener option to assure proper dispensing�
Load dispensers before starting a cycle�
It is normal for small amounts of water to remain in dispenser
at the end of the cycle�
Homes with low water pressure may result in residual powder
in the dispenser� To avoid, select a warmer wash temperature
if possible, depending on your load�
Liquid chlorine bleach not used
in dispenser or TimedOxi option
not selected�
Use only liquid chlorine bleach in the bleach dispenser�
You may only place Oxi products directly in the liquid chlorine
bleach dispenser. If using Oxi products, be sure to select
TimedOxi option. Do not use both liquid chlorine bleach and
Oxi product in the same load.
Powdered detergent
not dissolving completely
in load
Using too much HE detergent� Follow the manufacturer’s instructions to determine the amount
of detergent to use�
Water temperature is very cold� Select a warmer wash temperature�
Try adding the detergent to the basket prior to adding laundry
rather than using the detergent dispenser�
Single-dose laundry
packet not dissolving
Adding laundry packet incorrectly� Be sure laundry packet is added to washer basket before adding
clothes� Follow the manufacturer’s instructions to avoid damage
to your items�
Error Code Appears in Display
LF (too long to ll)
appears in display
Washer taking too long to ll. Drain
extends more than 4.5" (114 mm) into
standpipe�
Check plumbing for correct drain hose installation� Use drain hose
form and attach securely to drainpipe or tub� Do not tape over
drain opening� See Installation Instructions�
“--” Cycle knob is not on cycle� This is not an error� The selector knob is not on a cycle� Rotate
your selector knob until a cycle lights up�
F## code (F-type error
code) appears in display
System error code� Touch START/PAUSE/Unlock Lid once to clear the code� Then
touch START/PAUSE/Unlock Lid again to restart washer� If code
appears again, call for service�
TROUBLESHOOTING
First try the solutions suggested here for assistance and to possibly avoid a service call�
Loading ...
Loading ...