Loading ...
Loading ...
Loading ...
5
PLACEMENT AND INSTALLATION
To ensure that your beer dispenser works at the maximum efficiency it was designed for, install
it in a location where there are proper air circulation and electrical connections.
Choosing the Right Place
Choose a location where the beer dispenser will be away from any heat sources and will not be
exposed to direct sunlight.
Remove all packing materials before using the beer dispenser.
Place the machine on a smooth, flat and sturdy surface.
CAUTION:
Installation
After unpacking, you MUST allow this appliance to stand upright for at least 2 hours to
allow the lubricant and refrigerant to drain back into the compressor and stabilize.
Failure to do so may adversely affect performance and the lifetime of this unit.
Model SBC635MOS is not designed to operate in enclosed spaces. When placing your unit,
make sure you allow at least 4” of clearance at the sides, rear and top to allow for adequate
airflow. It is suitable for outdoor use.
Model SBC635MBI is designed for indoor use only. It can be installed either built-in or free-
standing. For built-in installation, you must provide the following clearances around the unit for
best operation and proper ventilation: 3/16” on both sides, 2” at the rear and 1/16” at the top.
Take care that the air vent at the front of the beer dispenser is never covered or blocked in any
way. For free-standing installation, follow the clearances mentioned above for the OS model
and be sure no air vents are blocked.
The SBC635MBI and OS beer dispensers meet UL Standards 250 and 471 and are suitable for
residential or commercial use.
Applications
Connect the appliance to a 3-prong power supply socket (which has a ground terminal).
Connecting to Power Supply
If you
only have a two-prong outlet, have it replaced by a qualified technician with an outlet that meets
the local codes
DO NOT USE AN EXTENSION CORD
.
Required nominal voltage and frequency are indicated on the rating plate. The connection to
the power supply and grounding has to be made according to current standards and
regulations. The appliance resists temporary voltage fluctuations with a tolerance of ±10%.
Outdoor model SBC635MOS is fitted with a GFCI safety plug to prevent short circuits during wet
conditions.
Once connected, allow the appliance to operate empty for two to three hours before putting a
beer keg inside.
Loading ...
Loading ...
Loading ...