Rheem 492400G8 400L 4.8KW Twin Element Electric Hot Water System

User Manual - Page 14

For 492400G8.

PDF File Manual, 40 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
WATER SUPPLIES
14
ANODE INSPECTION AND REPLACEMENT
The anode installed in your water heater will slowly dissipate whilst protecting
the cylinder. The life of the cylinder may be extended by replacing the anode.
For water supplies which are either softened or desalinated, or where the water
supply may alternate between a water tank and a reticulated public supply or
another supply, or where there is a variable supply (e.g. from a bore or public
reticulated supply from various water sources), the anode must be inspected
(and replaced if there is any sign of depletion) within 5 years of installation, and
within every 5 years thereafter.
For all water supplies, if the anode is not replaced during a major service (refer
to “Major Service Every Five Years on page 10) then in any event, the anode
must be replaced at 10 years.
CAUTION
If the water supply has a TDS greater than 150 mg/L and a green anode has not
been changed to a black anode, or if the TDS is greater than 600 mg/L and the
anode has not been changed to a blue anode, there is the possibility the anode
may become overactive and hydrogen gas could accumulate in the top of the
water heater during long periods of no use.
If, under these conditions, the water heater has not been used for two or more
weeks the following procedure should be carried out before using any electrical
appliances (automatic washing machines and dishwashers) which are
connected to the hot water supply.
The hydrogen, which is highly flammable, should be vented safely by opening a
hot tap and allowing the water to flow. There should be no smoking or naked
flame near the tap whilst it is turned on. Any hydrogen gas will be dissipated.
This is indicated by an unusual spurting of the water from the tap. Once the water
runs freely, any hydrogen in the system will have been released.
Warranty applies to a vitreous-enamel-lined water heater cylinder if the
correct coloured anode is used for the TDS of the water
Blue
Blue
ANODE SELECTION
Above 2500 mg/L, no
warranty applies to a
vitreous-enamel-lined
water heater cylinder
TOTAL DISSOLVED SOLIDS (TDS) mg/L
2500
Green
Black
0
40
150
400
600
(60)
(215)
(570)
(860)
(3570)
(CONDUCTIVITY - μS/cm)
0
Loading ...
Loading ...
Loading ...