Loading ...
Loading ...
Loading ...
#Tstailatiof; o Connecting Optional Ice Maker To Water Supply
To avoid electric shock, which can cause death or severe personaJ injury, disconnect the
refrig orator from eJectricai power before connecting a water euppJy line to the refrigerator.
To Avoid Property Damage:
- Copper tubing is recommended for the water supply line.Water supplytubing made of 1A" plastic is not
recommended since it greatly increases the potential for water leaks. Manufactarer witl not be responsible for
any damage if plastic tubing is used for suppJy line.
• DO NOT install water eupplytubing m areas where temperatures fall below freezing.
• Chemicals from a maffunctioning softener can damage the ice maker, ff the ice maker is connected to soft
water, ensure that the softener is maintained and working property.
IMPORTANT: Ensure that your water supply line connections comply with all local plumbing codes.
Before Installing The Water Supply Line, You Will Need
BasicTools: adjustable wrench, flat-blade screwdriver, and PhillipsTM screwdriver
o Access to a household cold water line with water pressure between 20 and 120 psi,
A water supply line made of 1Ainch (6,4 mm) OD, copper tubing, Todetermine the length of copper tubing needed,
you will need to measure the distance from the ice maker inlet valve at the back of the refrigerator to your cold water
pipe, Then add approximately 7 feet (2,1 meters), so the refrigerator can be moved out for cleaning (as shown),
o A shutoff valve to connect the water supply line to your household water system, DO NOT use a self-piercing type
shutoff valve.
A compression nut and ferrule (sleeve) for connecting the water supply line to the ice maker inlet valve.
NOTE: Water line kit number 5303917950, available from your appliance dealer at additional cost, contains 25 feet (7.6
To Connect Water Supply Line To Ice Maker Inlet Valve
1, Disconnect refrigerator from electric power source,
2, Place end of water supply line into sink or bucket, Turn ON water supply
and flush supply line until water is clear, Turn OFF water supply at shut
off valve.
3. Unscrew plastic cap from water valve inlet and discard cap.
4. Slide brass compression nut, then ferrule (sleeve) onto water supply line,
as shown.
5. Push water supply line into water valve inlet as far as it will go (1Ainch).
Slide ferrule (sleeve) into valve inlet and finger tighten compression nut
onto valve. Tighten another half turn with a wrench; DO NOT over tighten.
6. With steel clamp and screw, secure water supply line to rear panel of
refrigerator as shown.
7. Coil excess water supply line (about 2Y2turns) behind refrigerator as shown
and arrange coils so they do not vibrate or wear against any other surface.
8. Turn ON water supply at shutoff valve and tighten any connections that
leak.
9. Reconnect refrigeratortoelectrical powersource.
10. Toturn ice maker on, lower wire signal arm (see ice maker front cover for ON/
OFF position of arm).
Brass
Compression
ice. Air in new plumbing lines may
cause ice maker to cycle two or three times bef0re making a fu!!tray of !ce_New' plumbing may cause !cetObe disco!ored
or have poor flavor. Discard ice made during the first 24 hours.
Loading ...
Loading ...
Loading ...