Loading ...
Loading ...
Loading ...
General Care & Cleaning
Sealed Burner
To Clean the Burner Grates, Contoured Burner Skirts, Burner Cap and Burner Head
The burner grates, contoured burner skirts, burner caps and burner head should be routinely cleaned. Keeping the burner ports
clean will prevent improper ignitionand an uneven flame. See instructionsbelow.
To Clean the Burner Grates
Be sure burners and grates are cool before you place your hand, a potholder, cleaning
cloths or other material on them. The cast iron burner grates can be washed in hot soapy
water. Rinse thoroughly and dry the grates with a cloth; don't put them on the cooktop while
still wet. Be sure the grates are positioned securely over the burners.
To remove burned on food, place the grates ina covered container or plastic bag. Add 1/4
cup ammonia and soak for 30 minutes. Wash, rinse well and dry. An abrasive cleaner can
be used for stubborn stains.
To Clean the Contoured Burner Skirts
Burner grate can appear in
different shapes.
The burner skirts are attached to the cooktop and are not removable. The burner skirts forms a recessed well area located
around each burner unit. If spill occurs in one of the well areas, turn off burner and blot up spill with an absorbent cloth. Rinse
with a clean, damp cloth and wipe dry.
Burner Cap
Sealed Burner
To Clean the Burner Cap
Remove burner cap. Use soap-filled pad or mild abrasive cleanser toclean burner
caps. If necessary, cover stubborn spots with an ammonia-soaked paper towel ('::
for 30 minutes. Rub gently with a mixture of clean water and vinegar. Wipe dry. ......
Remove all cleaners orthe porcelain may become damaged during future heating.
To Clean the Removable Burner Head and Gas Opening (some models)
The ports (or slots) around the burner head must be routinely cleaned. Use a
small-gauge wire or needle to clean small slots or holes.
Note: If the electrode is damaged or broken, the surface burner will not light
because it will not spark. Manual lighting with a match is still possible.
For proper flow of gas and ignition of the burner - DO NOT ALLOW SPILLS,
FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS OPENING TUBE. Gas must flow freely through the small hole in the brass
orifice for the burners to light properly. If the gas opening orifice becomes soiled
or clogged, use a small-gauge or needle toclean. ALWAYS keep the burner cap
in place whenever a surface burner is in use.
To Replace the Burner Head and the Burner Cap
Make sure the pieces are thoroughly dry before placing back.
1. Replace burner head and burnercap intheir places. Make sure each burner cap
and burner head are properly aligned and leveled.
2. Replacethe burnergrate.
3. Turn the burner on to determine if it lights. If the burner does not light after
cleaning, contact an authorized servicer. Do not service the sealed burner
yourself.
13
Loading ...
Loading ...
Loading ...