Loading ...
Loading ...
Loading ...
– 17 –
8. PREPARING THE ANGLE GRINDER
8.4 FITTING GRINDING DISCS –
FIGS. 5 – 8
− Press and hold the spindle lock button (3).
Loosen the locking flange (4) anti-clockwise
using the pin spanner (7)supplied.
− The spindle may rotate slightly before the
spindle lock fully engages. Remove the locking
flange only.
− Clean the flanges and spindle prior to fitting any
accessory. If the rear flange is removed for
cleaning, ensure it locates correctly on the
spindle flats when refitting and does not spin
freely.
− When fitting the appropriate accessory please
refer to (Fig.4) for specific details on the locking
flange correct orientation as applicable.
− After placing the accessory, securely tighten
the locking flange clockwise using the disc
changing spanner (7) while holding down the
spindle lock (3).
Note: When using wire cup brushes the locking
flange is not required due to the design of the
brushes. When fitted check the accessory is
correct and, importantly fully secure on the spindle.
Warning! Never press the spindle lock button (3)
while the spindle is in motion.
5
6
FIG.
FIG.
7
8
FIG.
FIG.
(3)
(7)
(4)
Loading ...
Loading ...
Loading ...