Loading ...
Loading ...
Loading ...
5
• Persons can be injured if the device falls down.
• When setting up the device, make sure that the connection cables are not squeezed or damaged by sharp edges.
• Always install the cables so that nobody can trip over them or become entangled in them. Risk of injury.
• When selecting a place to set up the device, avoid direct, intense sunlight, vibration, dust, heat, cold and moisture.
• Make sure there are no devices with strong electric or magnetic fields such as transformers, motors, cordless
telephones or radio-controlled devices in the vicinity of the device, as they can cause interferences in the record
player.
• Never place the device on valuable or sensitive furniture surfaces without sufficient protection.
• When selecting the setup location, please take into consideration the room layout such as the whereabouts of the
nearest mains socket etc.
• The playing surface should be isolated from the floor surface.
7. Operation
Connection
1. Plug the mains plug into a wall mains socket.
2. Connect the product to a mixer or amplifier, if required. Ensure that all devices are turned off. Use a suitable cinch
cable and connect it to the corresponding connector at the rear of the product as well as the mixer/ amplifier.
Playing back records
1. Switch the device on by turning the volume control in a clockwise direction.
2. Remove the protective cap from the stylus.
3. Put a record on the turntable. Place a single-adaptor (puck) on the turntable axis, if needed, to play single records.
4. Set the playback speed (33, 45 or 78) by using the speed control.
5. Activate the auto-stop function, if required, using the auto-stop control.
- Position ON: At the end of the playback, the turntable will automatically stop turning.
- Position OFF: At the end of the playback, the turntable will continue to turn.
6. Loosen the rest clip.
7. Lift the pick-up arm by using the pick-up lift lever and move the pick-up toward the record. The turntable will begin to
rotate.
8. Lower the pick-up arm onto the record by using the pick-up lift lever. The playback of the record will begin.
9. Now set the volume with the volume control.
10. At the end of the playback, lift the pick-up arm by using the pick-up lift lever and move the pick-up arm back to the
pick-up support.
11. Lower the pick-up arm by using the pick-up lift lever and secure the pick-up with the rest clip.
12. Switch off the product by turning the volume control in an anticlockwise direction.
Playing back cassettes
1. Switch the device on by turning the volume control in an clockwise direction.
2. Insert an audio cassette into the cassette deck. The side with the tape has to face to the right side. The playback
starts automatically.
3. Now set the volume with the volume control.
4. To fast forward the cassette, carefully press the eject button until you hear a click sound. The button is now
Loading ...