Loading ...
Loading ...
Loading ...
PROBLEM
Poor cut- uneven
'ROUBLESHOOTING CHART
CAUSE
, ,,,,,,,,,,,,, ,, ,, ,,,
o Wom, bent or loose blade_
Excessive
vibration
Starter rope hard
to pull
Grass catcher
not filling (if so
equipped)
° Wheel heights uneven.
Hard to push
o Low engine speed.
Buildup of grass, leaves
and trash under mower°
Worn, bent or loose blade.
o Bent engine crankshaft.
o Engine flywheel brake is on
when control bar is released.
o Bent engine crankshaft.
o Blade adapter broken.
° Blade dragging ingrass.
o Cutting height too Iowo
° Lift on blade wom off°
o Catcher not venting air_
= Low engine speed.
° Grass is too high or wheel
height istoo low,
o Rear of lawn mower
housing or blade dragging
in grass.
o Grass catcher too full.
o Handle height position not
right for you.
CORRECTION
° Replace blade. Tighten
blade bolt.
o Set all wheels at same
height
° Set engine speed control
in fast position.
• Clean underside of
mower housing.
o Replace blade. Tighten
blade bolt.
o Contact an authorized
service center.
,, ,,,,,,,,
° Depress control bar to
upper handle before
pulling starter rope,
o Contact an atdhorized
sewice center.
° Replace blade adapter°
° Move lawn mower to cut
grass or to hard surface
to start engine.
° Raise CLAing height.
° Replace blade.
° Clean grass catcher.
° Set engine speed control
in fast position.
° Raise cutting height.
o Raise rear of lawn mower
housing one (1) setting
higher.
° Empty grass catcher.
o Adjust handle height to
suit.
17
Loading ...
Loading ...
Loading ...