Loading ...
Loading ...
Loading ...
1. Follow all cleaning instructions prior to storage.
2. Dry all parts, including the inside of the Water Tank.
3. Leave the tank cap partially loosened to prolong the life of the cap.
4. Preferably store in its original box, in a dry place away from high temperatures.
5. Follow all cleaning instructions after long periods of storage.
a
e
b
dc
6
Storage
f g h i
Replacing The Remote Control Battery - Push the tab to the left of the
battery tray towards the right to unlock the tray.
f
While the the tab is pushed,
pull out the battery tray.
g
Remove the battery from the tray and replace it with
a new 3.5 volt lithium battery (CR2025) with the positive side facing up.
h
Insert
the tray back into the bottom of the remote contol until it locks in.
i
Weekly Cleaning & Care
WARNING: Before cleaning always turn power o and unplug the unit from outlet.
WARNING: DO NOT rinse Base under faucet. To clean, wipe the Base with a soft cloth.
WARNING: DO NOT use any solvents or aggressive cleaning agents. Keep water away from the Air Outlet.
WARNING: DO NOT tamper with the Water Sensor.
About White Dust -Use of high-mineral content water may cause a white mineral residue to
accumulate on room surfaces near the humidier. The mineral residue is commonly referred to as “White Dust”. The higher the
mineral content (the harder your water is), the greater the potential for White Dust. The White Dust is not caused by a defect
in the humidier, but is due only to minerals suspended in the water from your tap.
WARNING: If you have hard tap water
STOP using tap water and visit our website (www.Air-Innovations.com) to purchase our Humidier Demineralization Filters or
use ONLY ltered or distilled water.
Tank Cleaning - Remove the Mist Nozzle from the top of the Water Tank then remove the Water Tank from the
unit. Turn the tank upside down, unscrew the Tank Cap and drain any water from the tank. Wipe the tank with
a soft damp cloth then rinse it with warm water inside and out.
Base Cleaning - Gently wipe the Base with a soft damp cloth.
White Dust Cleaning - If mineral deposits “White Dust”
are evident around the Ultrasonic Nebulizer
a
and Water Sensor,
clean these surfaces with a soft cloth and a small amount of
undiluted white vinegar. If necessary, mix a solution of 50%
white vinegar and 50% water and ll the Base with enough
solution to cover the Ultrasonic Nebulizer
a
. Allow it to soak for
an hour and then use the provided brush to gently loosen
build up on the Ultrasonic Nebulizer
b
. Put 1 cup of water in the
Base and wipe clean with a soft cloth.
WARNING: DO NOT
rinse Base under faucet.
Ceramic Water Filter Cleaning - Remove the Water Tank from
the humidier Base. Remove the Tank Cap
c
and rinse Ceramic
Filter thoroughly with tap water
d
, then replace on Water Tank.
Surface Cleaning - Clean all surfaces of the unit with a clean
damp soft cloth.
WARNING: When emptying the Water Reservoir on the Base,
make sure that the water is poured away from the Air Outlet
e
.
If water is poured into the outlet it may damage the humidier.
Loading ...
Loading ...
Loading ...