Loading ...
Loading ...
Loading ...
Setting Warmer Drawer Controls
Warmer (Warm & Ready TM) Drawer Indicator Light (some models)
The indicator light is located above the warmer drawer thermostat control. It turns on when the control is set, and stays
on until the control is turned off. The warmer drawer is inoperable during the self-clean cycle. The indicator light wilt not
come on during the self-clean cycle.
Removing and Replacing Warmer Drawer (some models)
Le_ Glide
shliddon rf_l
glide. Pullupon le_ levgr
whilepushingdownor1
rlzht lever.
Push down with finpr
Pullupwithfinger
Figure I
To Remove and Replace Warmer (Warm & Ready TM) Drawer
To Remove Warmer Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hex-head screw (see
figure 1). Using a 1/4" socket and ratchet remove the shield.
4. Locate glide lever on each side ofdrawer, pull up on the left glide lever and push
down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (see figure 2).
3. Align the glide on each side of the drawer with the glide slots on the range.
4. Push the drawer intothe range untillevers "click" (approximately 2"). Pullthe
drawer open again toseat bearing glides intoposition. Ifyou do not hear the
levers "click" or the bearing glides do not feel seated remove the drawe r
and repeat steps 2-4. This will minimize possible damage to the bearing
glides.
Figure 2
_'=_ _'IVA'L'I;t_II_[cl Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
17
Loading ...
Loading ...
Loading ...