Loading ...
Loading ...
WATER VALV
O Remove shipping plug from water hflet valve,
O Install a 90° elbow (3/8" N,P.T)fitting h,to the water valve using Teflon r'_ tape
or pipe thread compound. The opposite end of"the fitth*g should fit h_-eoming hot
water supply line. Position the end of the elbow towards the rear of the dishwasher
IMPORTANT: DO NOT connect a sweat type fitting directly to the water valve
as the required beat will damage the water inlet valve. Donot solder within 6"
(15.2 era) from the water valve.
CAUTION:With the door open, dishwasher may tip forward if
it is not se<ure in position to cabinet,
:, RAIR ROSEPREPARATION
_} Dishwasher drain must bave a 32" (812) loop. Drain hose may be clipped to either skle of the disbwasber (see diagram A) It is preferred
_,:_:.. that the drain bose be routed high enough to provide the 32" loop. If a loop eammt be put in the installation, an air gap (not included)
may be used.
Diagram A
IMPORTANT: Routing of the drain hose is most important to insure satisfactory operation. It is not recommended
to extend drain line beyond 7' (2.1 m). Howevei; sbou[d this be necessary, it must always be attached to a hne
of larger inside diametel: An accessory drain hose extension kit (#904204) is available through your autborized
dealel: DONOT route drain hose across the top of the tub, all bends must be gradual to prevent kinking or
co!lapsing of the hose,
IMPORTANT: Drain bose may change position even after installation, Toinsure proper operation, secure hose
to either side of cabinet wail, or to rob with bose dip (provided) to assure a 32" loop. Make certain there are
no kinks.
(Shleview of dishwasher)
IMPORTANT: I)o not attach the drain bose to any connection smaller than 1/2" I.D.
IMPORTANT: Never cut the corrugated portion of drain hose. All connections
must be made to rubber portions of drain hose. If cutting of drain bose is required,
do not cut past the 5/8" line.
-- .............. \
Mtflti flex Drain Hose
DRA|N
A 5/8" (1.6 era) LD (Inside Diameter) x 7 ft. (2.1 m) corrugated drain hose is positioned
on side of dishwasher tub.
Drain hose connection can be located on either Mde of compartment. Elevate drain hose
to a height of at least 32" (81 era) above the f'loox: If drain connection is to be made
below the floor; bose sbouM be left in the looped position. It may be necessary to extend
drain bose for connection. DONOT reduce the drain hose to less than 1/2" (1.3 cm) I.D.
(Inside Diameter).
+d+++_........
{ ' smoRIRG TRtDISRWASRtR
_1_ With the door latched, position dishwasher h* front of cabinet opening. Insert
drain bose through the opening provided_
Guidedisbwasher into the cabinet, puHh_gdrah_ hose through opening as you
proceed. Make sure drain bose is not kinked.
Loading ...
Loading ...
Loading ...