Loading ...
Loading ...
Loading ...
10 49-5000614 Rev. 1
ENGLISH
LOCATION REQUIREMENTS
• Place the air conditioner on a flat, level surface. For
optimal performance place portable 20” from exterior
wall. For all other sides a minimum distance of 30” should
be maintained
• Keep the air conditioner free of any obstructions such as
drapes, curtains, blinds, etc.
• The exhaust hose should be free of any obstructions.
• Do not place the air conditioner on an unstable or raised
surface because it could fall and cause damage or injury.
•
Do not place the air conditioner in direct sunlight or near
a heat source such as baseboard heaters, stoves, etc.
• The window panel can be installed in a window with a
minimum 20” (55.88 cm) to a maximum 46” (121.92 cm)
opening.
Questions? Call Haier at 866.907.1566 or visit our Website at: haierappliances.com.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT — Save these instructions for local
inspector’s use.
• IMPORTANT — Observe all governing codes and
ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions for future
reference.
• Skill level – Installation of this appliance requires basic
mechanical skills.
• Completion time – Approximately 1 hour
• We recommend that two people install this product.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
ÎÕÎÌÝÛÒÌÊÕÛÎÚÞÒÛÎÖÎ×ÝÜ
Some models require a 115/120-volt AC,
60-Hz grounded outlet protected with a 15-amp
time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the possibility of
electric shock hazard. If the wall outlet you plan to use is
only a 2-prong outlet, it is your responsibility to have it
replaced with a properly grounded 3-prong wall outlet.
CAUTION
Do not, under any circumstances, cut or remove the third
(ground) prong from the power cord.
Do not change the plug on the power cord of this air
conditioner.
Aluminium house wiring may present special problems—
consult a qualified electrician.
Power cord includes a current
interrupter device. A test and reset
button is provided on the plug case. The
device should be tested on a periodic
åäöìöåüéìõö÷óõèööìñê÷ëèÝÎÜÝåø÷÷òñ
äñç÷ëèñ÷ëèÛÎÜÎÝåø÷÷òñúëìïè
plugged into the outlet. If the
ÝÎÜÝåø÷÷òñçòèöñò÷÷õìóòõìé÷ëè
ÛÎÜÎÝåø÷÷òñúìïïñò÷ö÷äüèñêäêèç
discontinue use of the air conditioner
and contact a qualified service
technician.
RESET
TEST
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...