Loading ...
Loading ...
Loading ...
Additional Digital Control Panel Features
Additional features are located on the control panel at the top of
the refrigerator compartment.
GrocerySavor TM
The GrocerySavor TM feature assists with periods of high
refrigerator use, full grocery loads, or temporarily warm room
temperatures.
• Press GROCERY SAVOR TM to set the temperatures to the
lowest temperature for the freezer and for the refrigerator. The
GrocerySavor TM indicator light will remain on for 24 hours
unless manually turned oft.
NOTE: The temperature display will not change. After
24 hours, the refrigerator and freezer compartments return to
the previous temperature set points.
Acceler Ice 3x_Production
This feature assists with temporary periods of heavy ice use by
increasing ice production.
• Press the Acceler Ice_i touch pad to turn on the feature. The
accelerated ice setting will remain on until manually turned
off.
NOTE: When the Acceler Ice _i feature is on, the freezer
temperature will cool to the lowest temperature. When the ice
storage bin is full, the freezer temperature will return to the
normal set point.
Control Lockout
This feature will disable the control touch pads to prevent
unintentional control setting changes.
NOTE: Control lockout does not shut oft power to the
refrigerator.
• To disable the controls, press and hold the LOCK touch pad
for 2 seconds. To reactivate the controls, press and hold the
LOCK touch pad for 2 seconds.
Cut Hazard
Use a sturdy glass when dispensing ice or water.
Failure to do so can result in cuts.
IMPORTANT:
If you did not flush the water system when the refrigerator
was first installed, press the water dispenser paddle with a
glass or jar until you draw and discard 2 to 3 gal. (8 to 12 L) or
approximately 5 minutes of water after water begins
dispensing. It will take 3 to 4 minutes for the water to begin
dispensing. The water you draw and discard cleans the
system and helps clear air from the lines. Allow several hours
for the refrigerator to cool down and chill water.
NOTE: After 4 minutes of continuous dispensing, the
dispenser will stop dispensing to avoid flooding. To continue
dispensing, remove the glass and press the dispensing
paddle again.
When the refrigerator compartment door is open, the
dispenser will not dispense water and the dispenser control
panel will not display or receive input. The previous settings
will be retained.
Dispense Water
1. Press a sturdy glass against the paddle to start dispensing.
2. Release pressure on the paddle and be sure the water has
stopped dispensing before removing the glass.
NOTE: Water may have an off-flavor if you do not use the
dispenser periodically. Dispense enough water every week to
maintain a fresh supply.
12
Loading ...
Loading ...
Loading ...