Loading ...
Loading ...
Loading ...
ENGINE MAINTENANCE
Maintenance, replacement or repair of the
emission control devices and svstems may be
performed by any non-road engine repair
establishment or individual.
Checldng Oil Level
Oil level should be checked prior to each use or at
least every 5 hours of operation. Keep oil level
maintained,
Changing Oil
Change engine oil after the first 2 hours and every 50
hours thereafter. If you are using your cleaning system
under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often. ,
-Change oilwhile engine is stillwarm from running, as
follows:
• Drain fuel tank by runningpressure washer until
fuel tank is empty. .,
• Clean area around oilfill, remove oilfill
cap/dipstick.Wipe dipstickclean.
• Tip your pressure washer to drain oilfrbm.the.oil fill
tube intoa suitable-container. Whdh c_n-k_caseis
empty, return the pressure washer to upright
position.
• Fillengine crankcase with recommended oil until oil
level is at FULL point on dipstick. Do not overfill
above that mark. POUR SLOWLY.
When engine crankcase is filled to proper level,
install end tighten oilcap/dipstick.
ServiceAir Cleaner
Your engine will not runproperly and may be
damaged ifyou run itwith a dirty air cleaner.
Replace the air cleaner once every 100 hours of
operation or once each year, whichever comes first.
Replace more often if operating under dirty or dusty
conditions.Do not attempt to clean or oilfilter.
Replacements are available at your local Sears
Authorized Service Center.
To clean or replace the air cleaner, follow these steps:
• Remove screw on the air cleaner cover.
Remove dirty air cleaner carefully to prevent debds
from falling into carburetor. Discard.
Clean inside of tilter case.
• Install new air filter.
• Reassemble all parts and fasten securelyto the
carburetor with the screw.
Clean / Replace Spark Plug
Clean or replace the spark plugyearly or every 100
hours of operation.
,_ CAUTION: Disconnect spark plugwire fromspark plug and keep wire away from spark
plug.
• Clean area around spark plug.
• Remove and inspect spark plug.
• Replace spark plug if the electrodes are pitted,
burned or porcelain is cracked. For replacement
use Champion RJ-19LM or equivalent.
• Check electrode gap with wire feeler gauge and set
gap at-.030 inches, if necessary.
\
• install spark plug, tighten securely.
Carburetor
If you think your carburetor needs adjusting,see your
nearest Sears Service Center. Engine performance
may be affected at altitudes above 4000 feet. For
operation at higher elevations, contact your nearest
Sears Service Center.
12
Loading ...
Loading ...
Loading ...