Loading ...
Loading ...
Loading ...
Automatic Ice and
Water Dispenser (continued)
Order new filter cartridges through the
dealer where you bought the
refrigerator, or contact the Frigidaire
Consumer Assistance Center at 1-800-
944-9044. It might be good to order
some filters when you first install your
refrigerator. Be sure to ask for the RC-
200 PureSource Plus TM replacement
cartridge.
The Pure$ource Plus TM RF-200 ice and
water filter system is tested and certified
by NSF International, the nationally
recognized and respected, not for profit,
certification organization for public
health safety. The PureSource Plus TM
system is tested and certified to ANSI/
NSF Standards 42 and 53. See
performance data sheet for specific
claims. This system should not be used on
water that is microbiologically unsafe or
with water of unknown quality unless
the water has been adequately
disinfected before or after traveling
through the filtration system.
Rated service flow- .37 GPM
Maximum Rated Pressure- 125 PSI
Maximum Operating Temp. - 100 °
Changing the Filter:
Water quality varies throughout the world. To ensure the highest possible
water quality, change water filter every 6 months, or 200 gallons. Also, if
filter has been in a refrigerator that hasnot been in usefor awhile (during
moving for example), change filter before reinstalling refrigerator. Note
dispenser system will also operate without filtration (with filter cartridge
removed).
To change filter:
Refer to Figure 1 as needed. It isnot necessaryto turn the water supply off
to change the filter.
1. Set ice maker lever (wire signal arm) to the OFF(up) position.
2. Hold filter cup firmly, and unscrew counter clockwise (Figure 1). (Some
water could leakout asyou remove cup. This isnormal.) Filter cartridge
should come down with cup. If cartridge remains inhousing, pull down
gently, while twisting filter back and forth.
3. Empty cup of any substance.
4. The large o-ring (Figure 1) that seals the filter system sets in the o-ring
groove down inside the cup. Should the o-ring fall out during filter
cartridge replacement, simply place it back in the groove prior to
screwing the cup back in place. Ifthe o-ring becomes damaged, you will
need to order a new one from the Consumer Assistance Center.
5. Discard old filter cartridge.
6. Remove new filter cartridge from packaging, and install.
7. Placefilter cartridge in cup. The end with the small o-ring should be up,
out of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use Wrench To
Reinstall Cup. Filter cartridge will self-align ascup istightened. Besure
cup iscompletely tightened with Pure$ource Plus TMLogo facing
outward. Do Not Tighten Past Stop.
9. Set ice maker level on the ON (down) position.
10.Check for leaks.Open refrigerator door. Wipe any water drops from the
filter cup. Runa glass of water. If there isa leak, unscrew filter cup, and
reinsert the filter cartridge. Check placement of large O-ring (see
Figure1). Reinstall filter cup, making certain it istightened completely.
11 .Tocondition filter system and purge air from water line, run several
glassesof water through water dispenser. This will also assurethat the
purest water possible isstored in water tank.
Figure 1
Filter Housir
Small O-ring
Cartridge
Large O-ring _
Filter CupJ_'_i i
TWIST TO REMOVE
Loading ...
Loading ...
Loading ...