Loading ...
Loading ...
Loading ...
INSTALLING BITS
See Figure 6.
Lock the switch trigger by placing the direction of
rotationselector in center position. See Figure 3.
Open or close chuck jaws to a point where the
opening is slightly larger than the bit size you
intend to use. Also, raise the front of your drill
slightly to keep the bit from falling out of the chuck
jaws.
• Insert drillbit into chuck the full length of the jaws
as shown in figure 6.
• Tighten the chuck jaws on drillbit.
DRILLBIT
CHUCKBODY
CHUCKJAWS
CHUCKCOLLAR
RIGHT Fig. 6
• To tighten the chuck jaws on drill bit; grasp and
hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of
the arrow marked LOCK to tighten chuck jaws.
See Figure 5.
• Do not use a wrench to tighten or loosen the
chuck jaws.
_1= WARNING: Do not insert drillbit intochuck
jaws and tighten as shown in figure 7. This could
cause ddll bit to be thrown from drillresulting in
possible serious personal injuryor damage to the
chuck.
Fig. 7
REMOVING BITS
See Figure 6.
• Lock the switch trigger by placing the direction of
rotation selector in center position.See Figure 3.
• Loosen the chuck jaws from drillbit.
• To loosen: grasp and hold the collar of the chuck
with one hand, while rotating chuck bodywith your
other hand. Note: Rotate chuck body in the
direction of the arrow marked UNLOCK to loosen
chuck jaws. See Figure 5.
• Do not use a wrench to tighten or loosen the
chuck jaws.
• Remove drill bit from chuck jaws.
10
Loading ...
Loading ...
Loading ...