Loading ...
Loading ...
Loading ...
5
Q is the button for changing the Fahrenheit/Celsius scale. The original setting is Fahrenheit. Pressing
Q one time will change the display to Celsius. Press one more time and the display will revert to
Fahrenheit. When the temperature display shows Celsius, N is lit; when the display shows Fahrenheit,
M is lit.
R is the power switch. When the power cord is connected, press R and the appliance will start
working. Pressing R again will cause the appliance to stop working; the display, fan and compressor
will all turn off. When the machine is turned off in this way (with power cord still connected), the
temperature setting will not change when R is pressed again to turn the unit on. When the power cord
is disconnected or the power is otherwise cut off, the unit will return to its original setting of 12ºC when
R is pressed. If the appliance has been off for less than 5 minutes, the compressor will not restart at
once when R is pressed. This behavior is built into the control system to protect the compressor.
NOTE:
If the unit is unplugged or turned off, or if there has been a power failure, you must wait 3 to 5
minutes before restarting the unit. If you attempt to restart before this time delay, the appliance will
not start.
When you use the appliance for the first time, or restart it after it has been shut off for a long time,
there could be a few degrees variance between the temperature you select and the one indicated
on the display. This is normal and due to the length of inactivation time. Once the appliance has
been running for a few hours, everything will be back to normal.
Reversing the Door Swing
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please follow the instructions below. To make the reversal, you will find two hardware pieces
in a plastic bag inside the appliance: the top left hinge and the bottom left hinge. The bottom support
bracket is used for both sides.
1. Carefully lay the appliance on its back. Use cushioning to protect the floor and appliance.
2. Using a Philips screwdriver, remove the two screws and bottom right hinge beneath the door.
Keep the hinge in a safe place in case you need to reverse the door again in the future.
3. Carefully slide the door off and place it on a padded surface.
4. Interchange the plastic shaft sleeves at the top of the door.
5. Remove the bottom support bracket from the right side.
6. Remove the top right hinge and keep in a safe place in case you want to reverse the door in the
future.
7. Remove the screws from the top left and transfer to the right.
8. Install the top left hinge.
9. Install the bottom left hinge to the door. Do not over-tighten the screw.
10. Place the door back on the appliance, lining up the top hinge.
11. Install the bottom support bracket.
12. Adjust door alignment. When set, tighten screw on hinge.
13. Remove handle. Transfer the screw hole covers to the left and install the handle on the right.
Loading ...
Loading ...
Loading ...