Loading ...
Loading ...
Loading ...
Installation Instructions
[9] CONNECT TO ELECTRICAL POWER
To gain access to the transformer/power cord
assemblg, remove the salt hole cover from the
softener. Unclip the tabs on the rear of the top cover
and rotate the cover upward to remove. DO NOT
PULL OR DISCONNECT WIRING.
• The softener works on 2/4volt-60Hz electric
power. The included transformer changes
standard !20-volt AC house power to 2/4volts.
Plug the transformer into a 120-volt outlet onlg.
Be sure the outlet is alwags live so it can not be
switched off bg mistake.
+ Replace the top coven
+ Replace the salt hole cover.
PROGRAMMING THE CONTROL
PROGRAMMING THE CONTROL
/f_ smor+w__ bUuPtt(_n)
Display__ ([:_ DOWN (-)
.[:i:,] - .SELECT
L f _______ button
TOUCH or HOLD button
CONTROL SETTINGS REQUIRED upon installation
and after an extended power outage.
NOTES:
• WHEN THE TRANSFORHER IS PLUGGED INTO
THE ELECTRICALOUTLET, 12:00 PH (flashing), and
PRESENT TIME is displaued. Program the control
as instructed below.
If FT- - - or .... is flashing, use the UP •
button to set the correct model code as follows:
FT20 for GXSS20H. If you pass by the correct code
number, use the DOWN • button. Then press the
SELECT button to accept the correct model.
• A "beep" sounds while pressing buttons for
control programming. One beep signals a change
in the control display. Repeated beeps mean the
control will not accept a change from the button
you have pressed, and you should select another
button.
• To program the control, you will use the UP •,
DOWN • and SELECT buttons.
• Use the SELECT button to select the desired
control function.
SET PRESENT TIME OF DAY
1. Press the SELECT button until
PRESENTTIME appears in the
display.
2. Press UP • or DOWN • button
to set. The UP button advances
the time; the DOWN button
moves the time in reverse.
I U.CO _
.......................................................
I I ,._,,_A+
!.30
PRESENT TIME
If the present time is between noon and midnight,
be sure PM shows in the display. If the present
time is between midnight and noon, be sure AM
shows in the display.
NOTE: Each press of an UP • or DOWN • button
changes the time by one minute. Holding the button
changes the time at a rapid rate.
3. When the present time is correct, press SELECT to
accept.
10
SET WATER HARDNESS NUMBER
1. Press the SELECT button until
HARDNESS appears in the
display.
2. Press UP • or DOWN • button
to set your water hardness number in the
display. DOWN decreases the hardness value.
UP increases the hardness value.
NOTE: Each press of a button changes the display
by 1, between 1 and 25. Above 25, the display
changes 5 at a time (25, 30, 35, etc.). Holding a
button in changes the numbers at a rapid rate.
Loading ...
Loading ...
Loading ...