Loading ...
Loading ...
Loading ...
Pullupwithfinger Removing and Replacing the Warming Drawer (some models)
Len Glide
To Remove Warming Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Fig. 1).
5. Pull the Warming Drawer away from the range.
Pushdownwithflngel
Figure 1
Figure2
To Replace Warming Drawer:
1. Pull the bearing glides to the front ofthe chassis glide (See Fig. 2).
2. Align the glide on each side ofthe drawer with the glide slots on the range.
3. Push the drawer intothe range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated remove
the drawer and repeat steps I thru 3. This willminimize possible damage
tothe bearing glides.
NOTE: The Warming Drawer will NOT operate while inthe "Self-Clean" and "Oven
Lockout" modes.
_ Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the Warming Drawer.
Care and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining
the appearance of stainless parts. Please refer to the table provided at the beginning of the General Care & Cleaning
section in this Use & Care Manual.
Operating and Replacing the
Oven Light
Wire
Holder
Figure3
Be sure the range is unplugged and all parts are COOL
before replacing the oven light. Wear a leather-faced glove for
protection against possible broken glass.
Operating the Oven Light
The interior oven light willautomatically turnon when the oven door is
opened. Press _ to turn the light ON and OFF when the oven door is
closed. The oven light is located at the rear wall of the oven interior and
is covered with a glass shield held by a wire holder (See Figure 3). The
Glass Shield must be in place whenever the oven is in use.
To Replace the Oven Light:
1. Turn electrical power off at the main source and unplug the range.
2. Press Wire Holder to one side to release the glass shield.
3. Replace the otd bulb with a new 40 watt appliance bulb.
4. Replace Glass Shield over bulb and snap Wire Holder into place.
5. Turn power back on again at the main source (or plug in the range).
6. The clock wilt then need to be reset. To reset, see Setting the
Clock in this Use & Care Manual.
32
Loading ...
Loading ...
Loading ...