Loading ...
Loading ...
Loading ...
- 9 -
INSTALLATION INSTRUCTIONS
INSTALLATION VENTED TO THE OUTSIDE
1. FIXING THE HOOD TO THE LOWER
PART OF THE WALL CABINET:
This type of appliance must be tted inside
a cabinet or inside another type of support
structure. The overall measurements of the
range hood are given in gure 1-2.
- Before proceeding with installation op-
erations, remove the anti-grease lters in
order to make handling the device easier:
- Open panel B as indicated in Fig.3 - step
1.
- Pull handle C as indicated in Fig.3 - step 2.
- Remove the two light bulbs D turning
them counterclockwise by means of a
suction cup, as indicated in Fig. 3 - step 3-4.
- Remove the 4 screws E which secure the
two light xtures H (right and left) of the
hood as indicated in Fig.3 - step 5.
- Remove the light xtures H to make instal-
lation easier as indicated in Fig. 4 - step 6.
- Make sure the thickness of the wall ca-
binet is within the measures indicated in
Fig. 4 - step 8.1.
- Insert the hood inside the cabinet Fig. 4
- step 7 and make sure that the 4 springs
F snap in place.
Fasten the hood to the wall cabinet using
the screwdriver and the relative screws M
and tighten until the device is ush against
the cabinet Fig. 4 - step 8.
- Ret the two hood brackets H (right and
left) and secure them with the 4 screws
E which had been removed Fig. 5 - step
9-10.
- Screw the two light bulbs D back in place,
turning them clockwise by means of a suc-
tion cup, as indicated in Fig. 5 - step 10-11.
IMPORTANT - The range hood must
be secured to wall studs or use drywall
anchors capable of supporting 75 lbs.
Fig.2
Fig.1
Loading ...
Loading ...
Loading ...