Loading ...
Loading ...
Loading ...
12. Press two 1" Square Inner Caps (54) into the indi-
cated end of the Backrest Frame (15).
Attach a Plastic Foot (53) to the Backrest Frame
(15) with a #8 x 3/4" Tek Screw (62).
Attach the two Guard Plates (17) to the inside of
the Bench Frame (15) with four #8 x 1/2" Tek
Screws (56).
13. Orient the Backrest (14) and the Backrest
Backing (8) as shown. Attach the Backrest and
the Backrest Backing to the Backrest Frame (15)
with four 1/4" x 1 3/4" Bolts (58).
14. Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
15. Locate the Long Cable (80). Insert one end of
the Cable through the welded tube on the indicat-
ed end of the Cross Frame (11) and then through
a Pulley Arm (22). If necessary, use the tip of a
screwdriver to pull the end of the Cable out of the
Pulley Arm. Be sure the Cable is on the indicat-
ed side of the welded rod in the Pulley Arm,
Insert the Pulley Arm (22) into the welded tube on
the Cross Frame (11). Attach the Pulley Arm with
a #8 x 3/8" Screw (24).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Pulley Arm
(22) with a 3/8" x 1 1/2" Button Head Bolt (71)
and a 3/8" Nylon Jamnut (103).
12
13
462
17
14
8
t i'
Rod
.Slot
12
71
t/ 24
,,'t/
t
Rod
103
Loading ...
Loading ...
Loading ...