Loading ...
Loading ...
Loading ...
20308184
29
VFF Vent Free Fireplace System
Top Front
Left Log #11
Top Front
Right Log #10
Figure 49
Log #12 (SC2430EK
Enhancement Kit)
Figure 50
Log #13
(SC2430EK
Enhancement Kit)
Figure 51
10. Place top front right log (#10) onto mid right log (#6) by
placing notch on bottom of log onto locating block on
log #6. Rest bottom end of log onto grate bar. Figure
49
11. Place top front left log (#11) onto mid left log (#8) by
placing notch on bottom of log onto locating block on
log #8. Rest bottom end of log onto grate bar. Figure
49
Center Log #9
Mid Left Log #8
Figure 48
12. Place log #12 onto mid left log (#8) and mid rear log
(#7) by placing notch on bottom of log onto locating
block on log #8. Rest right end of log onto top of log
#7. Figure 50
13. Place log #13 onto log #12 and top front right log (#10)
by placing notch on bottom of log onto locating block
on log #12. Rest bottom of log onto log #10 and center
log (#9). Figure 51
GLASS ONLY PLACEMENT
NOTE: Two (2) bags of glass are supplied with the VFF32
replace and three (3) are supplied with the VFF36 re-
place. All of the supplied bags may be used to cover the
entire oor and burner. We advise against using additional
glass as too much can cut off the proper amount of air the
burner needs to operate cleanly. This may cause sooting.
1. Spread glass evenly in one layer over the entire oor
and burner. Be sure to use a single layer only over the
ported area so as not to impinge the ame.
2. Turn burner on and adjust glass over ported areas to
achieve an even, clean ame.
Figure 52
Loading ...
Loading ...
Loading ...