Loading ...
Loading ...
Loading ...
8
OPENING AND CLOSING THE DOOR
The doors are tted with uniform sealing strips to prevent warm air and moisture from entering the
fridge and freezer compartments.
Be sure that the doors and door seals are free from obstructions and form a complete seal around
the rim of the fridge/freezer cabinets. Over-stufng and/or unlevel installation of the appliance will
prevent a good seal. It might be hard to open the door immediately after the door is closed. This is
due to air contraction in the fridge/freezer cabinets. This pressure difference will equalize in a few
seconds, making the doors easy to open once again.
LOADING THE FRIDGE AND FREEZER
Avoid packing food too tightly around the cooling plates located on the back wall of the fridge/
freezer. Allow air ow around these plates to ensure proper operation.
When adding unfrozen food to the freezer for the rst time, ll the freezer only 1/3 full and wait
until that food is sufciently frozen before adding more. It will also help to cool food more quickly
if the food is packaged in smaller containers rather than large ones. Food packages more than 2
inches thick will cool slowly. Avoid placing warm food in contact with cold food.
NORMAL OPERATING SOUNDS
• You may hear faint gurgling or bubbling sounds when the refrigerant is being pumped through
the refrigerant coils.
• When the compressor is on, the refrigerant is being pumped through the appliance and you will
hear a whirring or pulsing sound from the compressor.
• A thermostat controls the compressor and you may hear a ‘click’ when the thermostat cuts in
and out.
OPERATION
Follow the instructions below to reverse the door on your appliance. Note: Before reversing the
door ensure your appliance is disconnected from an electrical power supply.
• Use a Flathead screwdriver to remove the hinge top cover ( pop the hinge cover up off the steel
hinge by the sides)
• Use a Phillips head screwdriver to remove 3 bolts from the hinge (remove the hinge)
• Lift the fridge door up and remove the door from the fridge
• Switch the 3 plugs from the left hand side to the right side at the top
• Use a Phillips head screwdriver to remove the 2 bolts from the middle hinge (remove the hinge)
• Lift the freezer door up and remove the door from the freezer
• Put the freezer door and fridge door away from your working zone so as not to damage them in
the process
• Tilt back the fridge and unscrew the bottom foot
• Remove both feet and the door support (remove the hinge)
• Switch the 2 plugs from the left side to the right side with (2 new plugs in the manual bag)
• Add the left hand side lower hinge bracket (image below)
• Reattach feet
• Add back freezer door
• Add back middle hinge
• Stand up fridge
• Add fridge door
• Add to hinge
• Add hinge cover
DOOR REVERSAL INSTRUCTIONS
Loading ...
Loading ...
Loading ...