Loading ...
Loading ...
Loading ...
FINAL INSTALLATION
(CONT.)
INSTALLING TWO OR MORE UNITS TOGETHER INSTALLING TWO OR MORE UNITS TOGETHER
(cont.) (cont.)
Position the two units so that, when joined, they can be rolled into their final position.
1) For KRP units, place the anti-condensation
insulator according to its directions.
2) Place the units side by side, and check leveling.
The two units must be at the same height before
connecting. (Item 3, this page)
The side connectors should just touch along their
length.
3) At the rear, mount the joining brackets to one
unit, then the other. (Item 2, this page)
4) The top may also require a connector. Install if
required/provided. (Item 4, this page)
5) At the front, attach the aluminum center
connectors together using the fasteners provided.
(Items D, previous page)
6) Snap the center trim cover into place.
(Item 5, this page)
MOVING TWO UNITS INTO FINAL POSITIONMOVING TWO UNITS INTO FINAL POSITION
Make sure the side connectors will fit the cutout
width. See “CHECK/ADJUST SIDE TRIM” on page 30.
The procedure is the same as for a single unit. See
following page.
1
2
3
4
5
© 2020 Hestan Commercial Corporation
29
EN
Loading ...
Loading ...
Loading ...