Loading ...
Loading ...
Loading ...
4
BASE ASSEMBLY
2. Connect the assembly
to the round board C.
3. Place the teflon pad in between
the assembly from step 2 and the
board D. Insert the black tube
from package 2 through the holes
in the centre of all the above.
1. Connect the board B to the
board A1 and A2. Make sure
the Sky-Watcher logos on
the board A1 and A2 are on
the outside. The side of the
board B with three small holes
should be facing the front.
5. Position the accessory tray
over the 3 holes in the board
B and secure with the 3 small
screws provided.
6. Attach the handle from package
4 to the board B with the two
screws and the Alen wrench
from package 5.
7. Unassemble the cylindrical
saddle side bearings and the
screws from package 5. Attach
the cylindrical saddle side
bearings to the inside of board A
and A1 using the screws provided.
4. Take the bolt from pacage 2 with a
washer on it and insert it through the
tube. Secure with second washer and
the nut using the two wrench provided.
Do not over-tighten the bolt. This will
prevent the mount base from freely
spin on the bottom round board.
8. Cover all visible small screws with the screw caps provided
D
C
C
Sky-Watcher
logo on the
other side
A2
A1
Sky-Watcher
logo on the
other side
This side on
the outside
B
A1
A2
Loading ...
Loading ...
Loading ...