Loading ...
Loading ...
Loading ...
9
Reversible Door
Instructions (Cont.)
G05I0103 new
3. With the refrigerator door closed, remove
center hinge pin. (Note the arrangement of the
upper and lower washers (some models) on the
hinge pin. The washers must be assembled later
in the same manner.) Open refrigerator door
enough to allow door to be lifted off the lower
hinge. Remove the two screws attaching the
center hinge. The third outermost screw under
the center hinge should be left in place. Save
hinge, pin, and washers (some models) for
reassembly later. Reinstall screws in original
holes.
G05I0106 new
2. Open the freezer door enough to allow it to be
lifted off the center hinge.
G05I0063
Hinge Pin
Washer
Lower Hinge
Bolts
or
G05I0099
4. Remove hinge pin, hinge, and the two bolts
attaching the lower hinge. Save the hinge,
hinge pin, washer (some models) and bolts
for reassembly later.
G05I0101
Freezer Door
6. After the handles are removed, remove door
stop from bottom of freezer and refrigerator
door. Reinstall on opposite side.
Refrigerator Door
G05I0117
Freezer Door
7. Reverse handles while doors are off. Remove
the two screws attaching handle to the bottom
of the freezer door. Swing bottom of handle
away from door, and slide handle straight up and
off of dovetail button. Remove screw and
dovetail button, and install on other side, using
the same holes as the nameplate. To move
nameplate to other side, remove nameplate from
its frame, turn frame upside down and install in
old handle holes. Insert nameplate into frame.
Reverse instructions for reattaching handle. Start
with handle offset away from door. Place top of
handle over dovetail button, swing handle into
an upright position and push upward, locking it
into place. Secure bottom of handle with screws.
5. Carefully remove the hole plugs from the hinge
holes in the center mullion and top of cabinet and
reinstall in the opposite set of holes.
G05I0098
Screws
Hinge
1. Snap off hinge cover at top of cabinet (some
models). With the freezer door closed, remove
the two screws attaching upper hinge to cabinet.
Lift the hinge up and off. Be sure to save screws
and hinge for reassembly later.
NOTE: Some models have “pocket” handles,
which are handles recessed into the side of the
door. On these models, only hinges will need
to be reversed. A handle is built into both sides
of each door.
Loading ...
Loading ...
Loading ...