Loading ...
Loading ...
Loading ...
Section 3 - OPERATING INSTRUCTIONS
3.3 CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height, as desired, to any position,
using deck lift lever. IMPORTANT: There is a foot
assist pedal located to the right front side of the
footrest. Always use this assist pedal to raise or
lower the deck to the desired cutting height. See
Figure 3.10.
2. Insert the stop pin to desired cutting height. See
Figure 3.11.
NOTE: The engine does not have to be running to adjust
cutting height.
DECK LIFT LEVER
SHOWN IN HIGHEST
POSITION
DECK LIFT
ASSIST PEDAL
FIGURE 3.10
FIGURE 3.11
3.4 OPERATION- MOTION CONTROLS
This machine is equipped with dual hydrostatic wheel
drive transmissions. Each hydro pump is controlled by a
separate motion control lever. The left lever controls the
left wheel drive hydro pump and the right lever controls
the right wheel drive hydro pump. These levers control
the direction of motion, Forward & Reverse, and the
speed of motion. Move both levers forward to propel the
machine forward. Move both levers rearward to propel
the machine in reverse. The speed of motion is
continuously variable from neutral (zero) to the
maximum. Moving the levers farther from the neutral
position will cause the speed of motion to increase. To
turn, move the lever on the side to which you want to
turn slightly rearward of the other lever. Move levers
slowly and carefully. DO NOT make sudden changes in
speed or direction. Always slow machine motion before
turning. To stop the motion of the machine, bring both
motion control levers to the neutral position. Engage
parking brake.
3.4.1, DRIVING MACHINE
1. Start engine. Release parking brake.
2. Drop motion control levers down from neutral
lock positions. See Figure 3.12.
3. Move motion control levers gently and with
caution in desired direction. See Figure 3.12.
FORWARD - Move both control levers forward.
REVERSE - Move both control levers rearward.
LEFT TURN - Move left control rearward or move
right control lever forward.
RIGHT TURN - Move left control forward or move
right control lever rearward.
ZERO RADIUS TURN - Move one control lever
forward and move the other control lever rearward
simultaneously.
WARNING
DO NOT make turns at high speed. Slow machine
motion. Move motion control lever gently and with
caution. DO NOT make sudden changes in speed or
direction.
FIGURE 3.12
WARNING
Zero-turning the machine at any speed can result in
operator disorientation, or in operator being thrown
from the machine, Exercise extreme caution when
executing a zero-turn.
12
Loading ...
Loading ...
Loading ...