Loading ...
Loading ...
Loading ...
5
Test Run
Before using the refrigerator-freezer, clean it and make a test run to see if the
following steps can be completed. If not, check the electrical supply. If the
cause of trouble cannot be located, contact your Summit dealer.
1. Set the Temperature Control Knob to the OFF position and then plug the AC
cord into an electrical outlet of 115 volts, 60 Hz. The motor should not run.
2. Set the Temperature Control Knob at the MAX position and let the unit
operate for 20 minutes. The freezer compartment should get slightly frosted
and the motor should run smoothly with a soft hum.
3. Then rotate the Temperature Control Knob counterclockwise toward the
MIN position. Before the pointer of the knob reaches the MIN position, the
motor should turn off.
Reversing the Door Swing
The doors of the refrigerator-freezer can be hinged on either side so that the
door swing can be suited to the location of the installation.
Tools Required:
• standard screwdriver
• large Phillips head screwdriver
• socket wrench (3/8")
In order to reverse the position of the door hinges, refer to the disassembly
diagram on the following page and follow this procedure.
1. Remove the hinge cap by twisting it off.
2. Remove the upper hexagonal-head screws. The top hinge and the freezer
door can now be removed.
ATTENTION
This appliance is equipped with a special Thermo-
stat Control Device. If the unit is turned off or
unplugged, YOU MUST ALLOW THREE (3)
MINUTES BEFORE RESTARTING OR REPLUG-
GING THE UNIT.
The unit will not start if you attempt to restart it in
less than three minutes.
Loading ...
Loading ...
Loading ...