Loading ...
Loading ...
Loading ...
This Owner's Guide provides specific operating instructions
for your model Use the freezer only as instructed in this
Owner's Guide. Before starting the freezer, follow these
important first steps°
INSTALLATION
Choose a place that is near a grounded electrical outlet°
Do Not use an extension cord or an adapter plug..
For the most efficient operation, the freezer should be
located where surrounding temperatures will not exceed
I10°F (43°C).. Temperatures of 32°F (0°C) and below will
NOT affect freezer operation. Additional compressor
heaters are not recommended.
• Allow space around the unit forgood air circulation.
Leave a 3 inch (75 ram) space on all sides of the freezer
for adequate circulation..
3' (75ram)AirSpace
1" (25ram)
Installation
NOTE: The exterior waits of the freezer may become quite
warm as the compressor works to transfer heat from the
inside. Temperatures as much as 30° F warmer than room
temperature can be expected.. For this reason it is particu-
larly important in hotter climates to allow enough space for
air circulation around your freezer..
LEVELING
The freezer must have all bottom corners resting firmly on
a solid floor. The floor must be strong enough to support a
fully loaded freezer. NOTE: It is VERY IMPORTANT for
your freezer to be level in order to function properly,. If the
freezer is not leveled during installation, the door may be
misaligned and not close or seal properly, causing cooling,
frost, or moisture problems,.
After discarding crating screws and wood base, use a
carpenter's level to level the freezer from front-to-back.
Adjust the plastic leveling feet in front, _½bubble higher, so
that the door closes easily when left halfway open..
Unpacking and Leveling/
CLEANING
Wash any removable pads, the freezer interior, and
exterior with mild detergent and warm water Wipe dry..
DO NOT USE HARSH CLEANERS ON THESE
SURFACES,
Do not use razor blades or other sharp instruments,
which can scratch the appliance surface when removing
adhesive labels..Any glue left from the tape can be
removed with a mixture of warm water and mild deter-
gent, or touch the residue with the sticky side of tape
already removed. DO NOT REMOVE THE SERIAL PLATE.
_To allow door to
close and seal properly, DO NOT let
food packages extend past the |rent
of shelves,
Shelf Front
Loading ...
Loading ...
Loading ...