Loading ...
Loading ...
Loading ...
1. Remove all food.
2. Disconnect refrigerator.
3. Clean the following items-paying
special attention to crevices-using
the appropriate instructions in How to
Clean Your Refrigerator:
• Walls, floor, and ceiling of cabinet
interior.
• Drawers, shelves, and gaskets.
4. Wash and dry all bottles, containers,
and jars. Discard spoiled or expired
items.
5. Wrap or store odor-causingfoods in
tightly-sealed containers to prevent
reoccurring odors.
6. Connect power to refrigerator and
return food.
7. After 24 hours, check if odor has
been eliminated.
If odor is still present...
1. Remove drawers and place on top
shelf of refrigerator.
2. Pack refrigerator and freezer
sections-including doors-with
crumpled sheets of black and white
newspaper.
3. Place charcoal briquettes randomly
on crumpled newspaperin both
freezer and refrigerator
compartments.
4. Close doors and let stand 24-48 hours.
5. Repeat steps 5 through 7 above.
If odor was not eliminated, contact
Sears Service Center. Referto back of
manual for phone number.
24
ERGYSAVINGIDEAS
> Avoid overcrowding refrigerator
shelves.This reduces effectivity of air
circulation around food and causes
refrigeratorto run longer.
> Avoid addingtoo much warm food to
refrigerator at one time. This
overloads compartmentsand slows
rate of cooling.
> DO NOT use aluminumfoil,wax paper,
or papertowelingas shelfliners.This
decreasesair flow andcauses
refrigeratorto run less efficiently.
> A freezer that is 73full runs most
efficiently.
> Locate refrigeratorin coolest part of
room.Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior by
using a section of cabinet or an
added layer of insulation.
> Refer to section in Use and Care
Guide on temperature controls for
recommended control settings.
> Clean door gaskets every three
months according to use and care
guide instructions.This will assure
that door seals properly and
refrigeratorruns efficiently.
> Taketime to organize items in
refrigeratorto reduce time that door
is open.
> Be sure your doors are closing
securely by leveling refrigerator as
instructed in your use and care guide.
> Clean condenser coils off as
indicated in the Use and Care Guide
every 3 months. This will increase
energy efficiency and cooling
performance.
To avoid electrical shock which can
cause seVeie personal injury or deaihl
disconnectpower to refrigerator
before replacing light bulb, After
replacing light bulb, connect power.
To avoid personal injury or property
damage, observe the following:
> Allow light bulb to cool.
> Wear gloves when re;)lacing light
bulb.
SECTION
1. Locatefinger
UPPER FRESH FOOD
gaps on each
side of clear light
shield. Insert
fingers and press in on each side of
shield. Pullshield down and remove.
2. Remove light bulbs.
3. Replace with appliance bulbs no
greater than 40 watts.
4. Replace light bulb cover by inserting
front tabs of light shield into slots
directly in front of light assembly.
LOWER FRESH FOOD
SECTION B
1. Pinch bottom tabs _- --_-_
(A) on light cover
and pull straight
out.
A
2. Remove light bulb.
3. Replace bulb with appliance bulb no
greater than 40 watts.
4. Insert top tabs (B) of light cover into
liner slots and snap bottom portion
over light assembly.
FREEZER SECTION
1. Remove icebin by
A
lifting front of bin i/_"f _,,_,1
and pullingout.
2. Remove light bulb
cover by pinching top tab B
(A) and pulling cover out.
3. Removelightbulb.Replacewith
appliancebulbnogreaterthan 40 watts.
4. Insert bottom tab (B) of light cover
into liner slots and snap top portion
over light assembly.
5. Replace ice bin by sliding in until bin
locks into place.
ICE AND WATER
DISPENSER
1. Locate light bulb inside top edge of
dispenser frame. Unscrewto remove.
lira
2. Replace light bulb with a _,
7-watt, 120 volt bulb.
Loading ...
Loading ...
Loading ...