U-Line UCLR1215S00B User Manual

Loading ...

USER GUIDE

Door Adjustments 2

u-line.com

SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

3. Remove door by tilting forward and lifting door off

bottom hinge. Retain shoulder washers; they will

be reused.

4. Remove three screws from hinge holes on the opposite

side. Reinstall into holes where the hinge was

removed. Take care not to scratch cabinet.

Remove bottom hinge:

1. Remove bottom hinge from cabinet.

2. Remove corresponding screws on opposite side of

cabinet. On some models there may be a nut behind

one or both screws on either side.

Install bottom hinge:

Install two or three screws, depending on model. Replace

nuts if used.

Prepare door for reinstallation:

1. Remove gasket. This will reveal mounting holes for the

magnet assembly

2. Remove magnet assembly from door with T-10 TORX

driver. Be sure to only remove the two screws holding

the assembly to the door. Reinstall on the opposite end

of the door

3. Rotate gasket 180°, aligning notch with magnet

assembly and pressing firmly into the gasket channel

starting at the corners.

4. Rotate door 180° to reverse.

Install top hinge and door:

1. Use alternate hinge supplied with unit and reinstall the

screws. Do not tighten..

2. Lift the door on to the bottom hinge.

3. Align flat edge of the hinge with the outer edge of the

unit.

4. Tighten three screws.

Align and adjust the door:

Align and adjust the door (see DOOR ALIGNMENT AND

ADJUSTMENT).

Install grille:

Install the grille.

Loading ...

U-Line UCLR1215S00B 1000 Series 15 Inch Stainless Steel Freestanding and Built-In Ice Maker