Loading ...
Loading ...
Loading ...
49-2000768 Rev. 1 15
INSTALLING ANTI-TIP BRACE
1. Slide the left corner into opening and push power
cord into the hole leading to the outlet location.
Thread the cord through as drawer is being pushed
back into the opening.
If the outlet is installed inside the opening, plug
the cord into the outlet. In this location, the excess
power cord should be coiled and taped to the right
side of the unit. Make sure the cord does not get
trapped by the drawer.
NOTE: Insure that the power cord does not contact
the hot surfaces on the bottom of ovens, cooktops,
or any other appliance.
2. Push the drawer back until the front flange is flush
to the cabinet front.
3. Open the drawer fully.
'ULOOSLORWKROHVWKURXJKWKHKROHVLQWKHRYHUODSSLQJ
frame, one on each corner.
'ULYHZRRGVFUHZVSURYLGHGLQWRHDFKFRUQHU
WARNING
ANTI-TIP PRECAUTIONS:
The anti-tip brace must be installed to prevent the
drawer from tipping forward when opened and loaded.
Failure to do so could result in personal injury.
Install 2x4 or 2x2 anti-tip
brace against rear
cabinet wall 9" from floor
to bottom of brace
2x4 or 2x2 runners
or solid bottom
9"
INSTALLING WARMING DRAWER
INSTALLATION INSTRUCTIONS
Installation Instructions
Loading ...
Loading ...
Loading ...